开云体育

Fred, As far as I know, the inconsistent state for turnouts only occurs when turnouts are using TWOSENSOR feedback and both sensors are active or inactive. Are you using TWOSENSOR feedback? Dave

Ken, You need two profiles in Preferences -> ConfigProfiles, one for the PR3 layout connection and one for the PR3 direct programming track connection. Preferences -> File Locations for each has the

Have you tried NCE turnout monitoring? https://www.jmri.org/help/en/html/hardware/nce/NCE.shtml Dan

I used to have this setup on a previous computer and for the life of me, I cannot remember how I made this work: I use PR3 to interface Loconet. I use Dropbox to maintain my roster and profile. 1) My

You don't say which hardware and command system you are using. You may need to add delay between turnout commands if you are using Routes to initialize on startup. If using scripts, add delay (250ms)

Hi When I start a session, all turnout are automaticaly set to Closed. But for an unknow reason, on time to time, a turnout can show as being inconsistent. Once inconsistent, JMRI cannot give any

Hi En-TACT You can use another Type A to Type B Cable. They’re common with connecting Printers, you would have one lying around etc. Install ALL Jumpers (No 1 I ignored) Set the Address of

Rick, Thank you for the expanded explanation of your intended goal. ?It certainly makes things clearer for any attempt to provide guidance! I believe there is much here to unpack and sort out, so

Hi all, *Background:* I have a mid-size n-scale layout (about 65 turnouts and 40 blocks) and am running NCE for most of it. NCE PH-Pro 5amp Command Station, 4x AIU01 & BD20 occupancy detectors, NCE

Answers to your questions ...... 1. I posted my question in the Digitrax Users IO group and they sent me here. 2. I have the DCC card installed and only try to run it as DCC , its at this time it

My suggestion would be to reset the decoder. That's the best way to remove any possible configuration issues being the cause. Granted I'm not thinking of any combo of configuration options that would

I hope this would not be CPU intensive parsing the DCC system

Thanks for the quick reply Steve Yes, I would like to see an option To update the matching DCC address Roster entries based on In the command station monitor I think this would be a great

Joe, The build report you attached above shows this train (NSVL 82) originates in Afton, runs to Lyndhurst then returns to Afton.? In your original post, you asked... So what exactly are you

Phil, can you share the Logix code? I have this same issue and found I need to drive a train into a nother blick to get the sensors to fire, so this woukd be a great help. FWIW, I do have JMRI setup

Ok

I would also recommend the option of backing up all of your Manifest, build reports, and switch lists.? Now you can go back in time to review what really was

Ken, You need to upload your file again. The wrong file ended up in ProblemsBeingWorkedOn/Ken Fordham. Dave Sand

If the train is not terminated after building, cars appear in the previous (starting) locations when JMRI is restarted or restored.? I did not see the word "terminate" in any discussion. Phil

I moved there this morning. KenF