开云体育

  1. Jmriusers
  2. Messages
Single Messages Topics Expanded Polls

Locked Re: JMRI Error: Service mode programmer NCE is offline. #nce

 

开云体育

Hi En-TACT

?

You can use another Type A to Type B Cable. They’re common with connecting Printers, you would have one lying around etc.

?

Install ALL Jumpers (No 1 I ignored)

Set the Address of the USB Interface to 10.

Select the Serial Port as shown in the Device Manager for your CH430 & verify connecting in the Device Manager by plugging/unplugging.

Select USB Version 7

For System, select Power ?Cab

?

Very important CHECK TICK Addition Connections to “ON”

Adjust the BAUD Rate “19200”.

?

Select SAVE.

?

Your Console should show V7.3.7

?

Regards

Marcus

?

?

From: [email protected] <[email protected]> On Behalf Of En-TACT
Sent: Thursday, 19 September 2024 1:00 PM
To: [email protected]
Subject: Re: [jmriusers] JMRI Error: Service mode programmer NCE is offline. #nce

?

I updated the CH340?drivers from v3.5 to v3.8.2023.02.? No change to my issue.? Again, after starting DecoderPro and after 10 seconds, the status goes from "... NCE is Online" to "... NCE is Offline".? ?

?

I'll review the video on YouTube, but I think it's something else.? Could it be the USB type A to USB type B cable I'm using?


Virus-free.
Join [email protected] to automatically receive all group messages.