开云体育

Hello Marcus, The jumpers are set to the following: 1 = OFF / 2 = ON / 3 = ON / 4 = ON What do you mean by, "Set the Address of the USB Interface to 10"?? If it's the COM port, it's set to 3. When

Ken, I am creating SSLs and now I understand how they work. All of the signals were created as virtual heads so I could place them on the LE panel and populate the Simple Signal Logic. Now that I am

Hi Dave There are 3 files on problems being worked on. All are not good? I will send another file tonight or tomorrow morning. Sorry for all this confusion. Best KenF

Hubert, It might be that you need to use "Request update of sensor" instead of "Request update of all sensors". Daniel LogixNG: IQ:AUTO:0004 ??? ConditionalNG: IQC:AUTO:0004 :::

Vdrien I dont think its that simple. The routines mentioned act on a transit to get the next section. The allocate extra can allocate 1 section further, but auto trains cannot always use it and it

Phil, sadly no joy for me on that LogixNX sensor polling command. it appears to run at startup and even if I force execution it, it still fails to give me block occupancy visibility on the panel. I

Mike, Look at the session.log file located at /Users/<username>/Library/Preferences/JMRI/log. Dave Sand

I use a Mac Mini M1 8GB for JMRI and LCC configuration. Five times in the past month, when using Layout Editor (the one with the grid panel) hiding a panel causes JMRI to halt with no keyboard or

Ken, I don't see any new files. There are two bad ones from the 24th. Dave Sand

Hi Dave I uploaded again yesterday

Hello Mike, I'm not sure if anyone in JMRI is using SPINS information to route cars. SPINS was created as an aid to help crews spot cars correctly. There is nothing that says you cannot use SPINS

Hi there, I have been using JMRI for a while but for the first time I am stuck with something. I am running some scripts but I think it yet not possible to do the following : I use a python script to

With JMRI not running, delete that line instead of altering it. It will be recreated when you start up JMRI again with that window in the default position. -- Peter Ulvestad JMRI Users Group

Ron, I tried it with locY + 20 pixel. That worked. Well, I tested on Windows 10 and I'm running JMRI 5.9.4. But I assume that it works on the RPi too. Quit JMRI before you edit the

Mike, If the diagram of the location is present at the location (on the facia, or perhaps lighting valance), then IHMO, the SPINS number could easily be presented on the JMRI paperwork, and should

I am using Steve Todd's excellent JMRI image for the RPi. When I open the Preferences window, the window always opens right at the top of the screen, and the Title bar is offscreen. I can adjust the

Glad to help.? You did make me smile! Dan

Correct.? No " If-Then-Else " for the type field, sorry. One way to fake it is to adjust the loco's move count to bias assignment to a train. You will still need two types of locomotives, switcher

Keith, The only intermediate signals I see on your layout are EB10/WB11. Intermediate signals are automatic signals between control points. I don't know what you mean by virtual signals. In any

Dave, So I can install Virtual signals at critical points? They dont need to be "on the layout"? Do you have any ideas with respect to the stopping distance being too far from the