开云体育

I'm probably in the minority, but I allow JMRI to assign locomotives to trains.? It gets all the locos moving around the layout.? Plus it helps with getting proper train lengths. What I would like

Keith, On your track plan, the signal aspect for entering the siding has a medium speed. That means the train has to reduce the speed to medium "before" reaching the signal mast. When you are going

Thanks for this Dan, I will check this out later today. Appreciated.

Thank you, Dan. Your suggestion works perfectly. I now have all the software mounted and I can get ready for a session now. You really been a special blessing and I sincerely appreciate it. I’m now

Thank you both, great stuff! appreciate the leads. Apologies for the previous typos! -- DiverseHobbies operates a: 10x16' HO multi track layout; Lenz LH101 throttle drives a LZV100 for JMRI Automated

Group; I am making progress but i am a little bit confused, as I don't think the the warrants are acting like they should.? Allow me to explain: Some background: My layout runs from Buffalo to

The Southern Pacific used 'SPINS', (Southern Pacific Industrial Numbering System). They just put a number to correspond with the track and/or industry serviced. The question is, has anyone else used

Pete, Thanks for the reply. I will have to wait for another build fail as I have built a new train. In the mean time let me explain Mr RR a bit. Afton is staging only. It is actually 5 drawers off

Fred, Do you get any errors in the JMRI system console? If so, use the "Copy to clipboard" button and paste the entire contents. Dave Sand

I think I'll do the same for the modular group. All the booster boxes I set up for the group and my home stuff have a circuit breaker feeding the track, set about .5 amp below the booster rating, the

Dave I am using Lenz system. For startup I set the delay between switch commands to 500ms. All my turnouts are "Direct " and Automatisation is "off" Fred

Thanks, Dave. Pity, though. Do you think that, as a change request, this could have legs? Wouter [email protected]> wrote:

Hubert, I am new to Logix, but found it easy to set up the command I needed. There is a reference page here: https://www.jmri.org/help/en/html/tools/logixng/reference/chapter1.shtml If you proceed

Ken Profiles Mick ________________________________ Mick Moignard Specialising in DCC Sound m: +44 7774 652504 The week may start M,T but it always ends WTF.

It sounds like the motor drive on the decoder for one direction has failed. Each direction has a seperate drive chip. Mick ________________________________ Mick Moignard Specialising in DCC

Robin, Thanks for the information. Dave Sand

Wouter, Profiles are always application independent. DecoderPro and PanelPro retain the last used profile in their properties file, DecoderProConfig3.properties and

Dave, FYI Exact Feedback (Loconet) also supports the INCONSISTENT state. Robin Robin Becker N3IX Engineering LLC San Diego CA <https://quadln.n3ix.com/> quadln.n3ix.com Sent:

Thanks Dave. Sometimes I think I've lost it. -- Ken NYNH&H, Old Colony Division, Cape Cod Branch (1949-1959) Loconet * JMRI 5.9.3 * OSX,Win10,Ubuntu Blog: Cape Cod Railroad (HO) – Newbie of an Oldie

Hi all, I have a good many profiles. Some of them are of interest only when I use DecoderPro, others exclusively when I use PanelPro and some are of interest to both. I'd like to limit the number of