开云体育

Yes, those are the parts needed. Follow the wiring chart. And, yes those wires in the cable are ultra-thin gauge. I found the best way to strip the insulation is just to use your fingernails to strip

Joe, Thank you for your reply. I am ready to order both parts, but would like to know which exact parts you used...I think you mentioned a possibility or concern of wires breaking. Here are the

Dirk: Earlier today I also posted an answer to your question and how I solved the same issue you're having. Not sure if you saw it. Yes, the correct cable is an Ameritron DB-10MY, which I also

Kent I know what you mean. I do build a lot of stuff, but when it comes to things like a control cable I'd rather buy premade instead of trying to round up the individual parts needed to make one.

Kent, Thank you for replying to my humble request for help in getting my?new Palstar LA-1K and brand new Palstar HF Auto and new Yaesu FT DX-10 to work well together. My call sign is AJ6XW. My

Thanks, Eric.? I figured it was just a typo. But ... Without casting aspersions on you or anyone else, permit me a reflection (not even close to a rant): Buying "pre-made" seems to be everyone's

The 7300 was/is notorious for overshoot, unless it's been corrected. The overshoot (RF output from the 7300 spiking considerably higher than the LA-1K likes) causes the LA-1K to protect itself by

You give no call sign so one cannot tell how experienced you might be with amateur radio, nor can it be determined what you might be doing wrong because you give no information as to what you are

Sorry that’s the acom cable. This one is the one I have but it’s out of stock. https://www.dxengineering.com/parts/ame-db-10my Eric D Clanton

That cable won't work at all. Both jacks on the LA-1k are DB9 (DE9, if you prefer).? Nine pins, not 15. It WILL work if you cut the 15 pin plug off and install a DB9 plug. 73, Kent K9ZTV .

I had the same issue with my IC-7300. The LA-1K would frequently kick out due to overdrive unless I ran the drive super low. Tried 3 different 7300s, same problem with all.? I understand the 7610

To key the amp you need to activate the PTT (push to talk). The FTDX10 doesn't have a PTT RCA jack, so you must use a specific cable, refer to page 11 in the FTDX10 manual. I ran into the same issue

This cable works well. https://www.dxengineering.com/parts/dxe-acomss-ysu10 And yes call Palstar

Call palstar. [email protected]> wrote:

Mine using the 7610 using 30 to 50 watts on a hex beam or vertical never goes to over drive then tried my 7100 from the mobile rig same results but if i forget and leave it on 100 it does. If If you

I everyone! I recently purchased a brand new Palstar LA-1K and the Palstar HF Auto. I cannot get the Palstar LA-1K to work.? Not sure what I am doing wrong. No wattage coming out of the Palstar

One needs to look at TX overshoot...

My LA-1K will do the 200-250 watts FT8 described by KT3V, but only on lower frequency bands - might actually do more, haven't tried that much lately. But on 10 & 12 meters, it will only do about 175

As I recall the continuous commercial service (CCS) rating for the LA-1K is about 225W output using 240VAC power line. And the SWR needs to be as close to 1:1 as possible. Depending on room

It is an Icom issue unless they've corrected the 7300's overshoot problem. 73, Kent K9ZTV