开云体育

Setup

Just received my new LA-1K. Love the AMP.? Just wondering if anyone else has a problem with the AMP frequency display not displaying the same frequency as the transceiver? Not a big deal but thought

Mine is pretty much spot on. It might vary a hz or so but that’s about all. Sent: Wednesday, April 11, 2018 12:51 PM To: [email protected] Subject: [la1k] LA-1K Frequency display Just received

*Mark in Palstar Engineering is submitting this response:* "The LA-1K's readout may be different than the radio display frequency because: Radios show the "carrier" frequency in *USB* or *LSB*. On

Hello, Just picked up a new LA-1K to go with my HF-Auto. My first concern is that I think I have a sticky relay, I'm getting an intermittent transmit delay, and the display on the Amp says "TX Wait"

I think the wait signal comes up when you close the PTT switch but have not sent power down the coax. So if you key on SSB and don’t talk, you will see wait. The bar graph on my LA-1k is no where

an earlier poster mentioned that the power meter on the LA-1K was inaccurate and, I guess by extension, the SWR meter as well.? At the present time I do not have a separate meter. Can I rely on the

The way the meter was designed it would be hard to get a good power reading anyway. There are no marks so you are only guessing that 600 watts is in the middle of the “600”. Best guess is when

Thanks, I guess I will have to bite the bullet and communicate with my buddy Larry Phipps J Gene Sent: Monday, April 23, 2018 3:38 PM To: [email protected] Subject: Re: [la1k] Power meter The way

So what's the most power you have seen on your LP-100 from the amp ?? I broke down and ordered an LP-100, kind of disappointed I had to just to get some accuracy.

I have not really put the coals to it because I have some RG8-x in the shack I want to replace before I do. However I ran it up to 1KW very very briefly. In all honesty I have been a ham for over

Pretty impressive ! Thanks

This is an excellent diagram. Can we put this on the Palstar Facebook page? Thanks, Pete Palstar, Inc. Sent: Monday, April 23, 2018 8:04 PM To: [email protected] Subject: Re: [la1k] Power

Hi Pete, Yes you may. Rich *From:* [email protected] <[email protected]> *On Behalf Of *Pete Kovacs *Sent:* Tuesday, April 24, 2018 8:22 AM *To:* [email protected] *Subject:* Re: [la1k] Power

Great! Thanks. I’ll put it on our Palstar Facebook later today: https://www.facebook.com/PalstarIncorporated/ Pete Sent: Tuesday, April 24, 2018 9:24 AM To: [email protected] Subject: Re:

Can anyone from Palstar address my relay concern and the "TX WAIT " ?? Thanks

Best thing to do is call us. If it says TX wait that's normally what you get when you ground the push to talk line, but RF is not being applied. Call us and we'll explain everything:?*800-773-793*.

*AMP FAULT CONDITIONS for V1.01B FIRMWARE* *1. SWR TRIP FAULT:?* Fault SWR stays on display until unkeyed.?Occurs with 2.5:1 SWR. SWR numbers also turn RED. ? *2. TEMPERATURE FAULT:*?When

Ordered LA-1K from HRO. Will be here in couple days. Any special concerns, issues I need to know in firing up new amp. Will be run on 240v. Reviews on Eham look positive. Thanks. Mike KB7ME

Its pretty straight forward. I have no issues with mine. Its going to take some getting used to for me as I am not accustomed to having a fan come on so quickly and the relay is pretty noisy. Not