开云体育

Power Drive for height and angle - worthwhile options. They seemed costly upfront, but over time I believe you will appreciate that it simply works and is repeatable. I just finished some legs for a

Cliff, Thanks for the details. Supposedly there is a grease fitting as the manual recommends using a grease gun. I have looked cursorily and not seen one. Will have to take a closer look in a day or

I have tried oil,? I have tried? wipe on Red grease, I have used the DowCorning dry lube with molybdenium disulfide (it is messy) and I have used? Lubriplate in a pressurized can. My? height

Thanks John. Surprised that it holds position good enough for the ext table. Either way, I am going to try it as, right now I only see the need to attach pressure modules for rip fence. Imran Sent:

Works good with pressure modules and Aigner extension tables with the support leg. I used standoffs so the whole rail could be utilized. You could drill and tap the Baltic Birch for a set screw if you

Hi John, This is definitely a low cost option. Is the ply block just sitting on the P rail or is there a set screw? Also if one is willing to sacrifice the ability to mount an accessory where the

Imran, I got those P rail Aigner mounts David mentioned and here's a couple of pics of a P rail to F rail mount that's super easy to make.?JohnJMK Services

Thanks David.

https://www.molykoteproduct.com/content/dam/Dupont2.0/Products/molykote/literature/en/Molykote_G-4500_Synthetic_Grease.pdf David Best - via mobile phone

Okay, since there is no response, I will ask the question differently. What are you using to lubricate the Saw Height/Elevation guide. I assume all motorized saw have this maintenance requirement.

that's what I'd do.? The Hammer? scoring is? pretty primitive. It works but it is uncomplicated and relies on simple mechanisms.

Hi Lucky, thanks for the details that really helps as your thoughts are in line with what I would want if I add the power drive option, I had remembered hearing about some issues but now I do think I

Hi David, Thanks for the link. I also see what you did with two modified couplings with flat bar in between. Do you use that often? The angle bracket is too limiting where it would not accommodate

Tom, I sent you a PM, if you are interested in one since Randy’s sold. Imran

Hi David: Good to see you posting on FOG. You’ve been missed. Warm regards, David Lucky Dr David Luckensmeyer Business Manager Luckensmeyer Medical Pty Ltd melissaluckensmeyer.com.au and Designer

No..sorry..It sold in minutes..I was surprised.. Thanks though Randy

I’m ran, the P-channel pressure module coupling including Felder part numbers is documented in this series: https://flickr.com/photos/53698949@N05/sets/72157679368916583 David Best - via mobile

The angle brackets may raise the pressure module too high for your application. Thanks, Chris Perren 512-415-6951

Aigner makes angle brackets that can be used with their regular mounts https://www.scosarg.com/aigner-angle-bracket-i Dave Davies wrote:

Not sure if this helps but Felder has a p channel attachment that can be used with aigner accessories.