开云体育

Still available?

Question, how great is the full power drive option on a saw, say k700 or k900? Worth the money? I could see the benefit of dialing in an angle other than 90deg or 45deg quickly and dialing in a

https://phoenix.craigslist.org/evl/tls/d/mesa-felder-cf-731s/7124902153.html Imran

Anyone interested in buying this hold down clamp? I got the Airtight clamps from Mac and no longer need this clamp. $125 shipped.. ( US only) Send me a PM if interested..

OK, I understand better now. Does Nordfab make a 30? ell? Put a 45 and 30 together at the wall to ceiling by the DC, that’s within 1? of your 106? (16? more than 90). Do a fitting close to the

Hi Joe, No shag carpet o well. Custom elbows , two barrels under The cyclone if you have the height. Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106

If it is not hardened steel? try? heat.? If it is? try less heat.? but? first apply? some wintergreen oil (not the synthetic stuff). ? that's the old school aircraft mechanics? penetrate of

Here are a few pics of the mess. The pipe will go up from the right side of the pics, follow the ceiling until a horizontal can clear the HVAC duct and go to the other side. A branch will run each way

Good idea, might have to try that. Brian Lamb blamb11@... www.lambtoolworks.com

I have one connection that I swap out with another.? I understand the? knurled knob? you have there.? My? way to skin that cat was to use pop-rivets to put a ring of sheet metal inside one of the

I’m sorry it was canceled. I’m sure there were more reasons than those stated for the cancellation. I suspect both the attendee enrollment was way down, and the number of exhibitors was also

You got lucky, usually once they start to gall, you are pretty much done for. =============== Brian Lamb blamb11@...<mailto:blamb11@...> Phoenix, AZ ===============

It was probably me not tightening the spindle rings enough and it caused the spindle’s metal to get rough where the cutter was located. The ring was getting stuck there. After getting the ring off I

I just about to make my airline and hotel reservations when the notice came through. Bummer?Take care?John.?Sent from my Samsung Galaxy smartphone.

Joe, The Nordfab custom elbow has very little flexibility during installation as far as changing the angle is concerned.? I chose this option when I ordered by ClearVue cyclone and Nordfab duct.? I

I built this back in maybe 1997, so it was pre-Thein. I’m sure I could improve on it, but it’s one of those things that you’ll always plan to get around to and rarely do. Brian Lamb

There were some huge logistics issues with European exhibitors, too - did not help the case. Looking forward to future shows and a real shame to wait two more years for this one.

Interesting on the garbage can separator I thought it might be a Thein design at first look. Used the Thein design on Shopvacs for good separation years ago. The filter was kept clean vacuuming

For those trying to decide whether to go to IWF in Atlanta this August ?you choice has apparently been made. Woodworking Network reports that it has been canceled. ?Hopefully, we can still look

I built the garbage can separator for the drum sander. I welded a rolled flange into the lid, added a cross beam and center bolt sticking down to attach a Cleanstream Hepa filter. Shortened a 5 gallon