开云体育

Be sure you are in Single Band operation for some features to work properly. As much as I love my VX-7r, I also get frustrated with how to access some of the sub menus and features. if you dont use

Hi Chris, I cured the the rememberance of all the menu items when I purchased the "Pocket Reference for the Yaesu VX-7R" by Hugh McCully VE3AYR Refer to attached photo At 79 very soon to be 80, I

I hope some are still watching. I have a VX-8R that I haven't used in several years. Am in a wheelchair because of foot surgery, and want to use the radio. But I get no audio out.? It seems to work

Hi Dave, I can think of a couple things you might check - * Is the squelch set too tight? * There is an Audio Mute feature - is it enabled?? How about the Squelch S Meter setting? * Did you

so, the first basic Question, and I hate asking it, as I believe you are smart enough, but is the BH1 adapter still in play with the radio? I assume not as you said you checked headphone/earphone port

Well, I was talking out my rear a moment ago. I thought I understood how the BH-1 worked. And while I do, I misunderstood that the BH-1 required an actual internal board, not simply an external

Thanks to all who responded. This is funny.? I actually have two VX-8R radios.? I did do a full reset on the radio in question. But still no RX audio. TX audio goes out, I can hear myself on the

One more question.? At the bottom right of the screen, next to the battery charge graph, there is a "S" that blinks.? Can't find in the manual what it is, or if it is supposed to blink.? Ya'll know

Blinking S is the battery saver indicator. Any chance you have Tone Squelch or Digital tone squelch enabled on receive? 73, Tad, K3TD

Thanks for the reply. Bluetooth is disabled.? I get sound thru a speaker plugged into the earphone jack.? Makes me wonder if there is just a wiring issue with the speaker.? Otherwise, it seems to

Dave, one final thought - there are two Reset procedures and they do different things.? One is a Microprocessor reset and the other is a Set Mode reset.? You might try both just in case.? If that

Not familiar with the set mode reset. Will look that up

How did this experiment go? I think my battery just died.

Hello, My VX-7r was sitting a couple of weeks without use, and the original FNB-80LI battery drained itself completely to show 0V. The battery has been heavily drained before, but it was holding

Hello, I have the barometer board installed in my VX-7R and the radio sets, in off condition, for several months before I turn it on again with no battery drain problem. First check to see if the

Hello Clyde, thank you for the reference. I keep discovering odd little bits that this radio does, like the timer, and I just saw the WIRES internet link. I generally just use it with manual frequency

Hi Tobias, I have found, refer to attached photocopy, the best, out of four, reference manuals for the VX-7R. It is small enough to fit in a shirt pocket and throughly shows all the features of the

There are No screws holding the case together. The three contacts that appear to be screws are not holding the case. They are battery charge contacts only. The case halves are bonded together by

Thank you very much! excellent documentation.I had no idea these packs used round cells. I have been doing ok with an Amazon or eBay battery, and using the original old battery as backup for

Yesterday I found that I could not use CTCSS on memory channels B. The same memory when used on A works fine. When in B, and I go to menu 95 SQL Type it is set to off, and cannot be changed. I cannot