开云体育

This was the predecessor to WiresX .Wires was very similar to the layout of the hri200 software and was used very similar to operating Echolink or IRLP in that you pressed the button to connect to the

Referring to the manual, YEASU'S "WIRES" is for use with a CPU for worldwide communications on the ham bands. As far as I can find, it is no longer used. Clyde KC7BJE

I’m afraid there is no such thing as digital modes on the VX-7. It’s a great HT though only analogue no digital modes.

I am curious about the function of the Wires/Internet button on Vx-7R. How does one use it? I am familiar with C4Fusion and WiresX on FT3DR, but not sure how VX-7R pairs up to that. I will appreciate

I am comforted that it's Yaesu being strange and not me being unable to figure it iut

That's a normal operation... Mine was like that.... need to remember that or disable vfo B [email protected]> wrote:

Yesterday I found that I could not use CTCSS on memory channels B. The same memory when used on A works fine. When in B, and I go to menu 95 SQL Type it is set to off, and cannot be changed. I cannot

Thank you very much! excellent documentation.I had no idea these packs used round cells. I have been doing ok with an Amazon or eBay battery, and using the original old battery as backup for

There are No screws holding the case together. The three contacts that appear to be screws are not holding the case. They are battery charge contacts only. The case halves are bonded together by

Hi Tobias, I have found, refer to attached photocopy, the best, out of four, reference manuals for the VX-7R. It is small enough to fit in a shirt pocket and throughly shows all the features of the

Hello Clyde, thank you for the reference. I keep discovering odd little bits that this radio does, like the timer, and I just saw the WIRES internet link. I generally just use it with manual frequency

Hello, I have the barometer board installed in my VX-7R and the radio sets, in off condition, for several months before I turn it on again with no battery drain problem. First check to see if the

Hello, My VX-7r was sitting a couple of weeks without use, and the original FNB-80LI battery drained itself completely to show 0V. The battery has been heavily drained before, but it was holding

How did this experiment go? I think my battery just died.

Not familiar with the set mode reset. Will look that up

Dave, one final thought - there are two Reset procedures and they do different things.? One is a Microprocessor reset and the other is a Set Mode reset.? You might try both just in case.? If that

Thanks for the reply. Bluetooth is disabled.? I get sound thru a speaker plugged into the earphone jack.? Makes me wonder if there is just a wiring issue with the speaker.? Otherwise, it seems to

Blinking S is the battery saver indicator. Any chance you have Tone Squelch or Digital tone squelch enabled on receive? 73, Tad, K3TD

One more question.? At the bottom right of the screen, next to the battery charge graph, there is a "S" that blinks.? Can't find in the manual what it is, or if it is supposed to blink.? Ya'll know

Thanks to all who responded. This is funny.? I actually have two VX-8R radios.? I did do a full reset on the radio in question. But still no RX audio. TX audio goes out, I can hear myself on the