开云体育

I had this problem the first time I updated the firmware. Tried 3 different Windoze machines before I found a laptop that would work. For this update I went right back to that machine and it worked

Download the firmware again your first download may be corrupt K4OCS Barry ?

Has anyone had trouble loading this version? I've tried two different PC's and I get an error message when trying to install. I've had the amp over 2 years and have done all of the firmware updates

1.07b is listed on the Palstar website Sent: Tuesday, July 28, 2020 1:09 PM To: [email protected] Subject: [la1k] Latest Firmware I am feeling really stupid, I cannot find the latest firmware.

http://www.palstar.com/en/la-1k_firmware/la-1k_firmware_1_07B.zip

I am feeling really stupid, I cannot find the latest firmware. V1.02E is the latest one mentioned on the site and non of the firmware versions listed is clickable? I hope the latest firmware may help

Digital is totally fine. No issues there very solid. Sent: July 27, 2020 8:44 PM To: [email protected] Subject: Re: [la1k] White screen I have had my LA-1K and HF-AUTO for about a year now.

Are you using any special cables between the Amp and the radio? It almost sounds like it’s a TX relay chatter or bounce. If you have a foot switch or some way to key the amp with the RCA jack

I have the LA-1K and HF-Auto in operation for ~18 months. A word of caution if one uses either the Key or ALC RCA phono plugs on the rear of the LA-1K. They are only connected to the rear panel

The last time I heard of someone experiencing this the issue ended up being their Balun. It was overheating and causing the SWR to be unstable. It was only with digital because that was the only

I tried that. All new factory made high quality cables all around. HF-AUTO shows something between 1.05 and 1.08, amp shows 1.2 or 1.3 (does this in SSB also), and then kicks off, almost always at the

Its giving you a SWR bypass using an HF-AUTO? What do the two SWR meters read when it trips? Try temporarily replacing the coax between the two. Sent: Monday, July 27, 2020 9:44 PM To:

I have had my LA-1K and HF-AUTO for about a year now. Overall they work very well, however I have a continuing problem trying to get any digital mode to work without having the amp turn off because of

My only complaint about the LA-1K is the noise. The base noise is already pretty substantial with a pretty high pitched hurling sound, but after 4 or 5 FT contacts at 5W input the bigger fans come on

I've had my LA-1K for 22 months.? I run it at 240 volts.? The very first time I put the amp into transmit, it showed 940 watts out with 35 watts drive. I was elated.? One minute later, I did

I hope that new shoppers don't get the wrong idea....Palstar is, in my opinion the Cadillac of tuners, amps, etc....the LA 1K issues will be solved by them i'm sure...their customer support is

My LA 1K will be a year old in August. I have not had any issues with mine. It’s a terrific amplifier!

Mine works great use it primarily on SSB and FM 10 through 160

I have no trouble with mine but I only use it on SSB and FM and I go from 10 to 160 and around and around and never gives me any trouble I use it on a 43-foot vertical and a hex beam

I would say all products have a certain percentage of units with issues. I have had none with my LA1K.? It has some software quirks to get used to, but nothing show stopping. The best selling point