开云体育

UPDATE: I assembled and installed the cable from the FTDX10 to the LA-1K and all seems well. The cable wires are extremely small and fragile and I just didn't trust the screw-down connectors to hold

Yes, I can confirm the DB-10MY cable is out-of-stock nearly everywhere. The alternative suggestion is the best way to proceed without having that hard to get cable. I've ordered the components (CSU-28

K9TRX: So glad you made your own cable.... once you have the parts then it is rather simple. Enjoy your rig and the AMP. It is a great amp. I also have the RFKIT RF2K-S ?amp as well. Have fun and

I cannot affirm that the cable you mention is suitable, but here is my experience. Mark at Palstar suggested the cable made for the Ameritron 1306 Solid state amp.? It is compatible with the LA-1K.?

Steve, Are you using the CT-118 with the ftdx-101 or the CT-178 which is the cable listed for the 101D/MP. Ron WD8T Sent from Proton Mail mobile

Thanks for the that info. Very helpful. Waiting on my parts to arrive and get the LA-1K on the air. Joe WW8X

Pardon the typo... Yes, it's SCU-28 cable for sure! Thank you.

PALSTAR YAESU CABLE TO LA-1K Here are the pin connections I made for the band data cable from the FTDX101D to the LA1K about a year ago. 101D ? ?LA1K DB15? ? DB9 2? ? ---? ? 7 ? TX 3?

Joe ... According to the FTDX10 manual, you want an SCU-_28_ cable for connection to the LA-1K (not SCU-18). Snip off the other end, and wire it to a break-out

I plan on doing something similar with my FTDX10 to the LA-1K. The FTDX10 uses a 10-pin mini din, so I ordered a Yaesu SCU-18 cable to connect to a 9-pin solder-less terminal connector. I just have to

Thanks Mike... the Linear jack shows 10 pins and the Tuner jack shows 8 pins. The link you gave has 9 pins. So, yes I'm still confused.

I purchased this from GigaParts, but they are out of stock. The cable is made by Ameritron.?https://www.gigaparts.com/ameritron-db-10my-interface-cable.html

I use one with my 101. Works good. You have to go into the menu and tell the amp that is what you are doing. You can also do away with the Keying line. Steve ________________________________ Sent:

I have a FTDX10 with the LA-1K.? I bought the cable needed off of ebay -> https://www.ebay.com/itm/194563158023 The cable goes to my MFJ998 ATU, and the output goes to the amplifier.? I have not

Does anyone have experience using a Yaesu FTDX10 to drive the LA-1K? Yaesu suggests using their CT-118 band data cable for their Yaesu amp. Would it also work for the LA-1K? Joe Loverti WW8X

PEP is just too high start with 15watts drive then move up. Monitor output power as you modulate the peaks. Good luck. It’s a wonderful Amp. Olen Persons 704-201-9446

This may be old news to some, but I found an interesting video demonstrating Bob Sherwood’s advice on how to avoid “hot switching” a linear amplifier with a IC 7300 and 7610. He suggesting

Much appreciated, thank you

True words, Jerry !

No problem. I run an FTDX101MP and I turn the LA-1K off when running the Yaesu at 200 watts. 73 kd4xr Jerry