开云体育

I renamed a block via a layout panel and all that happened is it created a new block with the old name, which I can't now find. Using PanelPro->Tools->Where Used to search for the block it says

David, it is the physical representation that is wrong. Green is correct. but when showing diverging the break in track should be on the left instead of the right of the circle. thanks -- Heath @

Doh, of course that would be prudent. That only happened in pic 2 ?because I kept clicking allocate next to see if it would make it. I tried using "no signals" and there was no issue so I conclude

Its a long shot, but is CV5 set too low or even zero. ( for loksound the motor is disabled by setiing cv5 = zero.) Steve G.

Stevemac If those are grade crossings / diamonds it will may not allocate across them if the other crossing track is allocated, and will not allocate across an occupied? block. As you are using

Sometimes it's only one or two loops. This time the train went maybe 5-6 then stopped presumedly because of the double mast stop (I don't see that specific aspect at

OK Another small step. Some decoders have a “disconnect” mode where you can power the prime mover WITHOUT engaging “drive”. If this is selected (or not actively unselected), you will

Heath, What do you mean by "orientation"? Is it supposed to be a left hand turnout? Do you just want the image to show the diverging leg when closed"? For the last question, you can use the

I am not sure what happened, but I have one turnout that ended up in the wrong orientation. I have the turnout and block detection and turnout position sensors all working, so I am trying to figure

Hi Dave, Many thanks for your assistance. The issue I was having is now resolved and did involve a Dropbox issue. The Mac OS Monterey had a goggle drive application in operation. ?Once the Google

All, Windows 10 JMRI 5.11.3 Noticed while running four of my trains in auto that if I have a derail and I try to stop all the trains some of them slow down to stop, but resume on their own upon

What is the address of the loco? If it is below 127, is it a long DCC address or a short DCC address? NCE is one of a small number of systems that allows you to put what are essentially short address

Linux Crew: Playing further with my flatpak install... One hoped for feature with a Linux release is a seamless update of a system. The flatpak install uses the same files structure for data but I

Randall, What system is your layout? Like what system are you using for the turnouts? Driving a signal lamp is really the same as driving a turnout motor. At least to JMRI. Look at 'Signal Heads',

You might also look at the standalone application for yard ladder control which I also implemented. Yard Track Selection Via Single Button Press For 6 Track Yard (

I use QuadLN_S boards for my turnout, detection, and signal interfaces. When used with JMRI Signal Mast Logic, the Quad translates Loconet signal messages into LED aspect

Phil G, Changing CV 29 to 7 results in the loco responding to the short address in the same way as previously reported. Meaning sounds are fine, but no loco movement. Regards

Peter, I had changed the Brake Key to FKey 7, but I always check to confirm that all FKeys are Off. Phil G, Let me try that and report back. Regards

Wanting to drive a Signal based on a decision 'to set green / red' from a LogicX - already set a sensor 'light' on the screen and switch turnouts,, looking for guidance to then set a dwarf

I have JMRI LogicX working through a tree/ladder of turnout to set 'a road in a yard' to the 'Main' from a touch sensor on a Panel.? Due to space, I am using two x three-way turnouts meaning I cannot