I have JMRI LogicX working through a tree/ladder of turnout to set 'a road in a yard' to the 'Main' from a touch sensor on a Panel.? Due to space, I am using two x three-way turnouts meaning I cannot use the turnout motor internal switches to switch leds on the Dward Signals on each road.
?
On the screen, I have a 'sensor' light next to the Road when it is clear to the Main.? All good so far and works fine.
?
Looking now for an addressable signal controller board to receive a JMRI command to turn a 'dwarf' signal from 'red' to 'green' when the sensor on the panel is selected (when it sets the required road to main).? ?The signal controller will connect to an AUX bus connected to, in this case, a NCE PowerPro Controller.?
?
What Signal Controller Boards are you using to take the command to change the LEDs from JMRI?
?
happy to answer any clarifying questions!
?
Thanks
Randall
?
?
?
?
