Re: Reorienting a turnout without completely deleting it. #layouteditor
|
Heath, What do you mean by "orientation"? ?Is it supposed to be a left hand turnout? ?Do you just want the image to show the diverging leg when closed"? For the last question, you can use the continuing route feature. This controls which leg is drawn when the turnout is "closed". ?This requires that the switch machine is wired to move the points to the diverging route when the JMRI turnout table state is "Closed". ?Note: ?You cannot use the "Invert" option as a substitute to fixing the wiring. Dave Sand ----- Original message ----- From: "Heath @ Human[c]ity Junction" <heath@...> Subject: [jmriusers] Reorienting a turnout without completely deleting it. #panelpro Date: Saturday, April 05, 2025 10:45 AM I am not sure what happened, but I have one turnout that ended up in the wrong orientation. I have the turnout and block detection and turnout position sensors all working, so I am trying to figure out if there is a way to just reorient the turnout without completely deleting it and then setting everything up again. ? I was looking for a way to "disconnect" the turnout, like you can do in Anyrail, but was able to figure out how to make that work. ? Any simple solutions or do I just need to delete and then re-add a new turnout in the correct orientation? ? ? ? -- Heath @ Human[c]ity |