开云体育

Vinny, I am also using Fully Kiosk and using multiple tablets on my layout. How are you currently navigating from one layout to another? Do you have a sensor button that loads another webpage? I

Chris, If highlight does not work, then none of the track has that block or a track segment is too short to be seen or it is hidden. Based on your original post, the block/layout block pair is not

All, CVs 2, 6, and 5 are 1, 50, and 140. Econamis have an engine interlock, bit 4 of CV 114, but I've never used that setting or set that bit. Regards

Very helpful thank you. What if it does not highlight any block though? I checked with other blocks and it highlights them, --chris

See /g/jmriusers/message/240878 .

I found all of my text label shown as on letter and dots or all dots. Is there a way to fix this? File uploaded. Stephen Marler

Heath, You flipped the A and B ends of the straight track. A should be attached to track segment T13 and B to T4. To fix this, use these steps. 1. Split T4 and T13. 2. Remove the new track

Chris, Try using the Highlight block option in the LE Toolbar. Dave Sand

I renamed a block via a layout panel and all that happened is it created a new block with the old name, which I can't now find. Using PanelPro->Tools->Where Used to search for the block it says

David, it is the physical representation that is wrong. Green is correct. but when showing diverging the break in track should be on the left instead of the right of the circle. thanks -- Heath @

Doh, of course that would be prudent. That only happened in pic 2 ?because I kept clicking allocate next to see if it would make it. I tried using "no signals" and there was no issue so I conclude

Its a long shot, but is CV5 set too low or even zero. ( for loksound the motor is disabled by setiing cv5 = zero.) Steve G.

Stevemac If those are grade crossings / diamonds it will may not allocate across them if the other crossing track is allocated, and will not allocate across an occupied? block. As you are using

Sometimes it's only one or two loops. This time the train went maybe 5-6 then stopped presumedly because of the double mast stop (I don't see that specific aspect at

OK Another small step. Some decoders have a “disconnect” mode where you can power the prime mover WITHOUT engaging “drive”. If this is selected (or not actively unselected), you will

Heath, What do you mean by "orientation"? Is it supposed to be a left hand turnout? Do you just want the image to show the diverging leg when closed"? For the last question, you can use the

I am not sure what happened, but I have one turnout that ended up in the wrong orientation. I have the turnout and block detection and turnout position sensors all working, so I am trying to figure

Hi Dave, Many thanks for your assistance. The issue I was having is now resolved and did involve a Dropbox issue. The Mac OS Monterey had a goggle drive application in operation. ?Once the Google

All, Windows 10 JMRI 5.11.3 Noticed while running four of my trains in auto that if I have a derail and I try to stop all the trains some of them slow down to stop, but resume on their own upon

What is the address of the loco? If it is below 127, is it a long DCC address or a short DCC address? NCE is one of a small number of systems that allows you to put what are essentially short address