开云体育

Pete, Thanks for the reply. I will have to wait for another build fail as I have built a new train. In the mean time let me explain Mr RR a bit. Afton is staging only. It is actually 5 drawers off

Fred, Do you get any errors in the JMRI system console? If so, use the "Copy to clipboard" button and paste the entire contents. Dave Sand

I think I'll do the same for the modular group. All the booster boxes I set up for the group and my home stuff have a circuit breaker feeding the track, set about .5 amp below the booster rating, the

Dave I am using Lenz system. For startup I set the delay between switch commands to 500ms. All my turnouts are "Direct " and Automatisation is "off" Fred

Thanks, Dave. Pity, though. Do you think that, as a change request, this could have legs? Wouter [email protected]> wrote:

Hubert, I am new to Logix, but found it easy to set up the command I needed. There is a reference page here: https://www.jmri.org/help/en/html/tools/logixng/reference/chapter1.shtml If you proceed

Ken Profiles Mick ________________________________ Mick Moignard Specialising in DCC Sound m: +44 7774 652504 The week may start M,T but it always ends WTF.

It sounds like the motor drive on the decoder for one direction has failed. Each direction has a seperate drive chip. Mick ________________________________ Mick Moignard Specialising in DCC

Robin, Thanks for the information. Dave Sand

Wouter, Profiles are always application independent. DecoderPro and PanelPro retain the last used profile in their properties file, DecoderProConfig3.properties and

Dave, FYI Exact Feedback (Loconet) also supports the INCONSISTENT state. Robin Robin Becker N3IX Engineering LLC San Diego CA <https://quadln.n3ix.com/> quadln.n3ix.com Sent:

Thanks Dave. Sometimes I think I've lost it. -- Ken NYNH&H, Old Colony Division, Cape Cod Branch (1949-1959) Loconet * JMRI 5.9.3 * OSX,Win10,Ubuntu Blog: Cape Cod Railroad (HO) – Newbie of an Oldie

Hi all, I have a good many profiles. Some of them are of interest only when I use DecoderPro, others exclusively when I use PanelPro and some are of interest to both. I'd like to limit the number of

Fred, As far as I know, the inconsistent state for turnouts only occurs when turnouts are using TWOSENSOR feedback and both sensors are active or inactive. Are you using TWOSENSOR feedback? Dave

Ken, You need two profiles in Preferences -> ConfigProfiles, one for the PR3 layout connection and one for the PR3 direct programming track connection. Preferences -> File Locations for each has the

Have you tried NCE turnout monitoring? https://www.jmri.org/help/en/html/hardware/nce/NCE.shtml Dan

I used to have this setup on a previous computer and for the life of me, I cannot remember how I made this work: I use PR3 to interface Loconet. I use Dropbox to maintain my roster and profile. 1) My

You don't say which hardware and command system you are using. You may need to add delay between turnout commands if you are using Routes to initialize on startup. If using scripts, add delay (250ms)

Hi When I start a session, all turnout are automaticaly set to Closed. But for an unknow reason, on time to time, a turnout can show as being inconsistent. Once inconsistent, JMRI cannot give any

Hi En-TACT You can use another Type A to Type B Cable. They’re common with connecting Printers, you would have one lying around etc. Install ALL Jumpers (No 1 I ignored) Set the Address of