Hubert,
I am new to Logix, but found it easy to set up the command I needed.
?
There is a reference page here:
?
If you proceed down as far as "Create an Action" and then select "Request update of all sensors", that is the only command needed.
When you close down the dialogue make sure "start up" is ticked.
?
Regarding the specific Lenz problem, I too have had problems with turnouts not operating after a short.? I solved it by putting circuit breakers between the LZV100 / LV102 and the track.? DCCconcepts in the UK do a product DCD-iPCB.1 which is very effective, although quite expensive (around UKP 80).? Also you would need two, one for each track feed.? I guess there are probably similar alternatives out there.
?
Hope that helps, Phil
?
