开云体育

Try this suggestion (from TB): Click on the "LOG-IN BOX" then F5 (refresh). Do this several times if necessary; it took me three times to get in to my account this afternoon.

As a follow up, The Analog/Time preset for TSW projects seems to be 'partially' broken - i.e. it does not update with incremental changes (but in a weird way...) FTR, I've i'm using Daniel's updated

We switched to Belden REVConnect as well and it has greatly increased our accuracy when terminating any kind of shielded category cable. Worth taking a look at if you're concerned about getting

Thanks, Daniel!? I'll check it out as I may have to use a different method. This issue appears to be related to VTPro and TSW/xPanels....? Loading my project on an iPAD works fine, just not on TSW

Thanks Wyatt, That actually worked for me also... If it doesn't work for others, as someone mentioned, try Save As to a 560P as this should render similar to the iPhone...

I spec REVConnect for all HDBaseT cable runs. Sent: Tuesday, June 22, 2021 11:33 To: [email protected] Subject: Re: [crestron] Long copper run and NVX In a related story, I would definitely recommend

In a related story, I would definitely recommend looking at the Belden REVconnect termination system. We've been using it for a while and I think it really helps to remove most of the 'Subjective'

I also have had various intermittent results with OLH login. I just tried it, and clicking on the main page help link did not log me in as current normal. I then searched for OLH#?1000443 and it

1 Reset the touch screen 10 times by pressing the micro switch behind the unit. You can start the next reset cycle as soon as you see the Crestron Swirl Logo. 2 After the button is pressed the 10th

Try this module /g/crestron/files/Count%20Down%20Timer%20v1.5.umc

I’m going to have to go back on-site to do some more testing and that is something I’ll give a try. Thanks Lincoln! Nate

I spoke to TB about it today as I've had a case open for a while (and I think Chris K has mentioned it a few times). They're aware of the problem - apparently it's not the same for everyone. Earlier I

Use the reset 10 time procedure -- Press the reset button on the back when the Crestron logo is displayed during boot Repeat 10 times Choose restore on the menu that pops up (I'm logged in to OLH but

That is odd; if you manually build a dial command (outside of the module) and send it does it by chance work? Wondering if perhaps the module rather than the codec is getting confused about the call

The reason I was going to Online Help... I have a TSW-1052 with authentication enabled, and no one wrote down or can remember the credentials. I have physical access to the panel, but don't know what

Is anyone else having trouble logging into Online Help (support.crestron.com) ? I've tried several times over the last couple of days, on three different browsers, cleared the cache/cookies, etc., and

Lincoln, Thanks for the reply. The crazy thing is that I’m not getting an error. I’m also utilizing the hangup all calls. It’s like the codec is ignoring all new call commands. The module stays

I believe one retrofit project I did the network design/configuration/commissioning for we had one run (Cat5-pre-E) with a cable run in the “it might have actually been slightly longer than 300

Can’t say I have – though most of my recent Cisco codecs have had the touch 10 as the only dialing control and using a Crestron processor (no TP) as an interface to lighting/shades/HVAC and AV

Hello All, Has anyone seen an issue with an SX80 only allowing you to make one call and then having to reboot it before you can dial/make another call from the Crestron panel? You can still make calls