开云体育

We've also used the Skaarhoj ATEM link with no issues on a few jobs.? The nice thing is with it, you can use the control software from BMD and the Skaarhoj will tell you what command was sent from

Hello Guys, I'm doing project with Lutron Radio Ra2 integration. Using Modules from the Files section ( Lutron Radio RA2 Modules for Crestron r05 ) Dimmers are working fine, but I can't figure our how

I have had good luck with the?Sony VPL-VW1000ES module (I've used both the serial and IP versions)

Pretty sure it's 9600 on the hdbt serial port.? Having said that, it can be configured for anything you want in the service menu, but outta the box it's 9600.

Sony projectors use 38400 Baud on the 9pin Sub-D, but 19200 9600on the RS232 over HDBT. (Corrected Baud Rate, thanks to Bambam_101) +1 for EVEN as mentioned by Brendon, both on Sub-D and RS232 over

Thanks Tony, the column width was the issue. Resolved! Best regards Crestronfreak55

I also found this when I opened up toolbox on an old virtual machine. If I recall correctly it was something to do with the low resolution setting I had in the virtual machine, I just had to resize

Where you able to get any integration with DSC Neo?? Looking for way to control it. Luis

Thanks, That did the trick.? Everything acquired and working now.

Sony projectors use even parity, it's tripped me up once or twice. -Brendon Brendon Packwood

Check your baud rate.

I have been using IP and CEC to control displays for quite some time. I am now working on a system using RS-232. There are 2 Sony Bravia panels that are working correctly, but I am having issues with

Hi All, sorry for the late update. Unfortunately I had the same issues as described by Sébastien LENOIR: no reliable communication. I ended up adding a Skaarhoj TCP ATEM Link device. This thing is

Give us your Software versions list....

Hi Folks, I think I had this before, but cannot remember the root cause/solution. In Toolbox Debugger, the trace shows the state changes, but not the signal names anymore. I did not change anything

Thanks. I thought the console symbol could only be used for the processor and not a connection to the UC Engine? I can see port "41797: Tunnel is ssl: unknown service" is available on the UC Engine, i

Contrary to the suggestions above, I would recommend using the Gather() or GatherAsync() functions for this with CRLF as the delimiter. -- Crestron Service Provider - TBD Enterprises Inc.

Yes. I use it quite frequently, it's part of the Foundation I put into all my programs. I use it on the settings page for a "PROGLOAD -P:ALL, Named "Install Update".? This is so I can load code to

I Believe that shades can have multiple addresses, so you can send a "1","2","3" for individual shade control; "5" for Room Control; and "20" house control. It sounds like your shade has both

Hi, I encountered the same problem this week with a customer with 2 units and the only solution was a restore as well. ?I have had this problem following several power and network outages.