Re: Cisco SX80 not allowing more than one call
|
Can¡¯t say I have ¨C though most of my recent Cisco codecs have had the touch 10 as the only dialing control and using a Crestron processor (no TP) as an interface
to lighting/shades/HVAC and AV automation) ¨C what error do you get back from the CLI when you try the 2nd call ?
?
Is it possible you aren¡¯t cleanly disconnecting the first call and if the codec isn¡¯t licensed for multipoint because it thinks it¡¯s still in a call it won¡¯t
allow an additional call. If you issue the hang up all command before (not just ¡°hang up call 1¡±, etc.) that might help to clean the deck.
?
--
Lincoln King-Cliby, CTS, DMC-E-4K/T/D
Commercial Market Director
Sr. Systems Architect | Crestron Certified Master Programmer (Diamond)
ControlWorks Consulting, LLC
Direct: (+1)440.771.4807 | Cleveland: (+1)440.449.1100? | Boston: (+1)508.695.0188 | DC: (+1)202.381.9070? | Fax: (+1)440.449.1106
Crestron Services Provider | Biamp Authorized Independent Programmers | Extron Qualified Independent Programmer
?
toggle quoted message
Show quoted text
From: [email protected] [mailto:[email protected]]
On Behalf Of Nate via groups.io
Sent: Tuesday, June 22, 2021 11:51 AM
To: [email protected]
Subject: [crestron] Cisco SX80 not allowing more than one call
?
Hello All,
Has anyone seen an issue with an SX80 only allowing you to make one call and then having to reboot it before you can dial/make another call from the Crestron panel?
You can still make calls using the touch 10 no problem.?
We have updated firmware on the codec as well as rolled it back to see if that was the issue.
I can't seem to find what the problem is.?
Nate
|
