开云体育

Hi, to be honest, i?m not completely sure I understand your problem. I understand the communication and control is working via Toolbox debugger, but not using your TP? I?m not sure if this is an

If you would like the ozone set, email me at gmail. jwmelvin

Has anyone successfully gotten the Apple TV homekit integration to work in simpl? I believe I have it set up correctly, I do have control of the Apple TV commands, but the voice control does nothing.

I think i can work with that. thank you

I'll take both if that's okay. Thank you!

I agree that the Power Supply may be the issue (although it is not completely dead, which is weird).? good news that it is an external P/S and is easily replaced. And yes, you can use a different

I have replaced power supplies in a few PAC2M units.? They are failing due to age.? Replace the power supply with a LPS65.? You can purchase one from Mouser Electronics:

Analog buffer adds top to bottom, so you could stack each needed string in the desired order in an ABuf and then when you hit enable it will make teh output string what you want.

Hi Thorsten! Thanks for the reply. ?I originally and reverted to just using the Trinnov supplied 2.1.9, with absolutely nothing changed or added. ?After that would not show connected, nor work, from

Hi, i?m usually not using the connect signal at all on the Trinnov module. It should work right away. Can you share your code? Which module version are you using? Cheers, Thorsten Von:

Thanks for help so far greatly appreciated I had my Crestron guy come over he tried reading any error codes onPac2 through usb port on ?bottom next to Lan. ?But nothing showed up and we couldn’t

The biggest issue I see with Series 2 processors is failing power supplies.? Virtual every series 2 external power supply are failing at this point.? You might try replacing the power supply.? Even

Re check your phoenix blocks, maybe rescrew down the connections, intermittent 24 y z g short [email protected]> wrote:

Hi All! Any help appreciated-seems I am missing something "Simpl." ?I have a Trinnov Alt 32, 4/23 build and a Pro4 with a 1070 panel. ?I can run all commands from debugger with good results, with

You could try to take all the command into an or, the output of the or to the sio first part, the output of the or also enable a buffer, all the commands go into that same buffer, the outputs of that

Howdy, this would be my first post on here. I'm not familiar with the "manners" of these posts, so I apologize in advance. I'm new to Crestron programming and I know enough to look at a program and

If you're still having issues with the LAN cable disconnected, the issue is not network related. This could be a problem within the processor, or maybe a Cresnet device that is misbehaving - This will

Nmap your ip from outside your lan. All ports Do you have brocast storms going on, sniff with wireshark, storm control Ports going into a temp down state Second dhcp somewhere on the lan Sniff your

Hi Chris thanks for replying back so greatly appreciated To answer your questions 1. ?I am the end user of the system but have a great knowledge of how system put together as helped design it and

Unfortunately, history has shown this to be true... :-) I'd love to be wrong about this one though.