开云体育

I've gone back to square 1 here to try and get this working. I've got rid of my program and am just using the one supplied with the module. I've uploaded it to my QM-RMC. (Was using an AV2) I made the

Shake Shack and Max Brenner are a couple of my favorite places there. I also really like Rosa Mexicano, but it is somewhat of a smaller upper level chain place. Mark

So now that my memory was just jogged, I've been meaning to post on here. This Saturday I'm headed to Manhattan for the 6th time. However this is the first time where it's a purely personal trip, no

If you (or anyone else) ever end up needing a TPS-4L I have two brand new in a box units in my basement. I had them for sale for $150CDN each O.B.O. I'll even be in Manhattan from May 4-8 ;). I could

So, whatever you plug the HDMI cable (and Vanco balun setup) into at the equipment rack causes the loop to appear on any of the component sources that run through the pvid? _____ From:

We have two PTL-4s lying around that we're never going to be able to get rid of and we need to do an equipment replacement for a project affected by Sandy that has a now discontinued TPS-4L in it. I

I am only polling Power, Source, Mute, Lamp Hours. I was getting the ERR back even when I was only polling Power

If I take the time to create a module for a specific projector, I would stop polling for everything but power status when it's off.

I have created a module for our Epson G5450 projectors. Everything seems to work but I have a couple questions. 1. When the projector is "Off", I get a ERR\x0D when polling the projector, I will

[Moderator's Note: Yahoo Group mangles email addresses (presumably to help protect people from spam), so if you want your email address exposed for everyone to see, do something to trick Yahoo like

I would check the same thing. You can pick up a cheap coax ground loop isolator from the shack or get something like the Jensen at the bottom of this page.

If you disconnect the cable from the cable did tou continue to see the loop? {Paf} Le 1 mai 2013 16:48, "weddellkw" <weddellkw@...> a 閏rit : [Non-text portions of this

You could also use an ATOD symbol. Negative numbers are the only ones that have the highest bit set. - Chip

Although, take a look at the help file, I dont remember if the acomp has a signed/unsigned parameter.

There you go

my values are generated with an INIT, and can range from -2d to 32d. I just gave it some more thought, and I'm thinking I can compare my value to 32,768, instead of zero, and when my value is > 32,768

Where are you getting the values from, self generated or from a device/feedback? And what is the range of values you're comparing?

I was trying to use everyone's favorite symbol, Analog Comparison (Full Set), to tell me when an analog signal was either positive, negative, or zero, but then I realized it is treating analogs as

Or you can use an abuf driven by the digital press join of the slider.

I have a client who would like us to install a simple multi-zone music/intercom system in a guest house. He is looking for: 2-4 sources, where one of the sources is an iPod 4-6 zones includes an