Where are you getting the values from, self generated or from a device/feedback? And what is the range of values you're comparing?
toggle quoted message
Show quoted text
--- In Crestron@..., "floyd1212" <floyd1212@...> wrote:
I was trying to use everyone's favorite symbol, Analog Comparison (Full Set), to tell me when an analog signal was either positive, negative, or zero, but then I realized it is treating analogs as unsigned values. Needless to say, I was never getting an indication that the value was negative.
Is there a combination of symbols I could use instead for getting the results I'm looking for? I actually only need to know when the value is >= 0, or < 0.
TIA
