开云体育

web site not found

hello gang, I will be announcing by end of month new products on WWW.VE2DX.COM ( /g/ft817/WWW.VE2DX.COM ) , mini din 816/818 bluetooth or optocoupled cat interface and also an ft1000

Thank you Phill. for the tips. 73s regards HNY Unni VU2TE

Whether to fuse the line when using a fused power supply it depends on where the power supply fuse is before or after the transformer. Fuses are intended to prevent the wiring from becoming a fire

Thank you James for the tips 73s GD GL HNY VU2TE Unni

Send me specs and priceWill put it on the 857 group if you want me toRegarddSent from my T-Mobile 5G Device

Did anyone else need a nice FT857?

WHAT???? --------------- Regards, Tony VA7TF VE&ACF Sent: January 5, 2021 12:10 PM To: [email protected] Subject: Re: [FT-857] 857D DC power cable problem For many years I have never fused my radios

For many years I have never fused my radios with the exception of those installed in a vehicle which I fit with a fuse in both positive and negative lines. My radios are normally used in the bush

Thank you Cliff. will go a new cable . I will connect direct till I get a new cable as there is no spare rig Unni VU2TE [email protected]> wrote:

Always best to have fuses in line.? Best to Install new fuse holders or get a new cable. Sent from AOL Mobile Mail

To day I had a problem with DC power cable of? my 857D. One of the fuse? gave problem with rig intermittently switching off.? When I checked the fuse unit got hot hot and the holder became loose.

There is a resistor in series with the line in that opens very often. I would check it, see the service manual

Jim I also find I can decode FT8 better with the AGC set to auto, not off.? Not sure why.? Pitty on your 590S, it's a great rig. But won't signslink's kenwood 12 pin connector cable work? That's

Jim Yes my signalink is connected to the rig via the data port.? My rig's settings are menu 19 CAT rate is 4800.? I never tried higher; menu 20 is CAT; menu 37 is 45; menu 38 is User U; menu 40 is

Cliff, Thank you . Are you connected to the FT-857D via the Data Port? My connection from the Signalink is to the FT-857D Data Port. (Note: I was using my Kenwood TS-590s on ft-8 with no problems

Well, I found at least part of the problem. I was trying to use Port 25 with SatPC32 and it will only recognize up to 16. Don't think that will fix my desire to use port sharing but at least I can get

Jim I've experienced issues like yours as well.? As a work around I have set wsjt-x and my 857D up to work digital in VOX mode.? I also have usb CODEC settings at 100% and control I/O primarily

ft-8 Transmit not working with FT-857d and Signalink - Receiving: ft-8 OK Setup: Signalink-USB with SLCAB6PM cable to FT-857D Data Port Signalink -USB with USB cable to Laptop PC Signalink Jumper J2

Mike, I had a similar requirement with my K3, and the VA2FSQ Win4K3Suite software solved that problem for me.? VA2FSQ sells a similar port sharing package called Win4YaesuSuite, but unfortunately it