Re: NO ft-8 TX with FT-857D - Signalink interface and wsjt-x ¨C Need guidance
¿ªÔÆÌåÓýCliff, Thank you .?? Are you connected to the FT-857D via the Data Port? ???My connection from the Signalink is to the FT-857D ?Data Port.? ?(Note:? I was using my Kenwood TS-590s on ft-8 with no problems until a pre-driver mosfet failed.? There is no Signalink interface connection with the TS-590S. ? Jim W2EKE ? From: [email protected] <[email protected]> On Behalf Of Cliff E via groups.io
Sent: Monday, January 04, 2021 10:55 AM To: [email protected] Subject: Re: [FT-857] NO ft-8 TX with FT-857D - Signalink interface and wsjt-x ¨C Need guidance ? Jim Sent from AOL Mobile Mail On Sunday, January 3, 2021 Jim Kennard <[email protected]> wrote: ft-8 Transmit not working with FT-857d and Signalink???-? Receiving: ft-8 ??OK? ??? Setup: Signalink-USB with SLCAB6PM cable to FT-857D Data Port Signalink -USB with USB cable to Laptop PC Signalink Jumper J2 both pins, J3 one pin, J4 both pins Signalink FT-857D Jumper settings for 6-pin-mini-din cable per Signalink website Laptop PC Windows 10 update SOUND Output: Speaker (2-USB Audio CODEC) Master - Volume 50% SOUND Input: Microphone (2-USB Audio CODEC) - Volume 50% Radio Setting Menu: 19)? 38400 bps 20) CAT 36)? 0 Hz 37) ?50 38)? USER-U 39) ?0 40)? 0 AGC:? ?OFF wsjt-x? settings General :? Call:? W2EKE????? Grid:? FN13gb Display and Behavior:? preferences set CAT Control: Serial Port:? USB?????????? PTT Method:? VOX Baud rate:? 38400??????? Data Bits?? 8???????????????????????? Transmit Audio Source (selection not active) Stop Bit:??? 1??????????????????????? Mode:?? USB Handshake: None??????????? Split Operation:?? Fake it Power Selector:? @ -5.9db TEST CAT:? Rig Failure -? IO Error while operating connection to rig Note: while momentarily listening to audio from internet it triggered transmit of Signalink and FT-857 ? Any suggestions and guidance to get ft-8 TX working would be greatly appreciated. ? 73? Jim |
Jim Kennard