开云体育

The required cable wiring is in the Files section of this group. /g/DINAH/files/Alinco%20DE-X35%20DE-9%20Connector%20Wiring%20to%20DINAH.pdf

The Dinah has a six pin mini din connector so maybe there is away to adapt it or have a cable made with a connector for 6 pin mini din and one for the DB9. Just need the pinout for both ends. Les

Yes. I ordered a cable from hammadeparts which works fine. The DR-135T MKIII does not work at 9600 baud but works fine on 1200 baud.

Does DINAH work with the Alinco DR-135T MKIII? It has a DB-9 port on the back. Not without a 6-pin DIN to 9-pin serial adapter… With one, it probably sounds great. The Alinco has nice unfiltered

Great! Speaking of Dinah... <https://www.youtube.com/watch?v=WBHIVlUmQrQ>

That is what I am finding with the IC-207H.? I found that is does have CTCSS for receive but COS is send to the node even though CTCSS is enable for received.? I would prefer not to key up all of

Does DINAH work with the Alinco DR-135T MKIII? It has a DB-9 port on the back. Peter W2PMS

DINAH Found! Peter W2PMS

I have one. Never been used. Mario WO5O

Hi, Does anyone have a fully assembled and working DINAH they would like to part with? Thanks, Peter W2PMS

The 207H has a 6 pin mini din on the back of it. Les Keegan N4LPK

Hi Patrick, I deliberately did not mention the Ftm series because he specified 6 pin din.

Hi: Two radios I can think of off the top of my head, and I'm sure there are others, may be overkill: The Kenwood TM-V71A has the option to chain COS for the data port to squelch in one of it's menus,

Kenwood tmv71a

I am a novice with the DINAH? interface.? I have it working with a used radio that I picked up cheap, an Icom IC-207H.? When I bought this radio I wasn't aware that it did not have the capability

Thanks Don. Sent: Saturday, May 6, 2023 6:28 AM To: [email protected] Subject: Re: [DINAH] using 9600 baud output for Allstar instead of 1200 This is the easiest way to change wiring to 9600 baud for

Greetings: Now, the received audio from my Kenwood TM-V71A sounds much, much better as it is sending flat, after de-emphasizing in SimpleUSB, and using the DCS filter, than the AF-stage filtered 1200

This is the easiest way to change wiring to 9600 baud for DINAH. Mobilinkd has such a cable commercially available:

Greetings: Today, I got a cable made up for me that essentially reverses pins 4 and 5 on a standard 6-pin DIN. This basically does the same thing as jumping the 1200/9600 pad on the? DINAH, but it's

Steve, I'm not as tech savvy as it might seem. The DR-735 passes everything in TNC mode, even if the received signal does not have the proper CTCSS/DCS encoding as defined in the DR-735 settings. As