开云体育

I decided to turn on CTCSS on my Allstar/Kenwood TM-V7. I thought I would be able to open up the squelch but it apparently turns on COS when the squelch is open but no station is transmitting? Has

A setup procedure for the HamVOIP image is in the Files section of this group. /g/DINAH/files/HamVOIP-Allstar-Node-Setup-and-Configuration-Guide-by-KG8MM.pdf

I thought a Dinah was a sound card Interface? How do u properly " set up" a Dinah?

The Icom706MK2G is initially (Factory) set in menu for 9600 baud. Check, or change Initial Set Mode Items, Menu #29 for 1200 baud. Page 54 of the Icom 706MK2G manual. Double check the In/Out levels of

I will double check when i have change to tinker with the setup.? I will give an update once i revisit the setup.

it is on an RPI - Debian. Worked fine on my TM733A but when I changed radio to ICOM706MK2G I can't get it to work. I will revisit the TX/RX settings once I get a change. WIll keep you posted.

What’s wrong with Hamboip? Sent from Chris's iPhone.

Yes, this is well known.? But, the levels for the sound-modem adapter must be correctly set. In Linux/Raspbian, alsamixer is used to properly adjust levels.

What OS are you running Echolink/Allstarlink on?? Did you adjust the TX/Rx levels? A DINAH is not "plug&play".? It must be properly setup. N1XP

DINAH is compatible with the data jack wiring on the 706MK2G. Is the red LED on DINAH on when the radio is transmitting? What setting are you using for I) in simpleusb-tune.? It should be active low.

ICOM-706 MK2G has a 6 PIN DIN connector at the back of the radio. It appears from the schematics that the pins are compatible with the DINAH. I am using an RPI with Echolink/Allstarlink software

For the Allstarlink software.? You can download the software from allstarlink.org Since you're using the RPI 4,? I would like to suggest you download and install the? Allstarlink ASL 2.0.0 Beta

Unplug the DINAH and try again.? If it does not boot then you have a problem with the Pi, the image on the uSD card or your Pi Power supply. Do any LED's on the Pi light up?

I did that and there was nothing.

Most probably your uSD card with the Allstar image is corrupted.? Plug a monitor into the Pi and tell us what you see when the Pi boots up.

Need to know if my Dinah is gone out or it just needs to be reset?? ?I unplugged it and pulled the card out and reinserted it and plugged it back in but no power light on it. Thanks!

Thanks for all the help. My Allstar Node has been running for a few weeks now. I have it linked to a local node and hooked up with old friends,? we used to be on the local repeater. All the

echolink setup info https://hamvoip.org/howto/echolink_howto.pdf is straight forward. 73 de j69ds

https://hamvoip.org/howto/echolink_howto.pdf

Make sure that u have already registered your Echolink and validated , so that u get a -l . The Echolink area in Allstar is located in etc/asterisk.