开云体育

Sorry,? I found "External Accessories" in the menu. Within the configuration window, I found "Rx Audio Output" was set to "De-emphasized". I changed it to "Flat" and that provided flat audio from the

Privileged info Mick Might cost a nickel of two Are you prepared? queue in THE GREEN DOOR by Jim Lowe 1956 John VK4JKL

But that doesn't tell what you found. Mick - W7CAT

Ahhhhh, I found it! Thanks all! Jim

The "FLAT/EIA" setting is a Radio Wide Configuration feature. Each channel has provisions for bandwidth and deviation, but nothing for De-emphasis/pre-emphasis. Jim

Here is some info from my notes: You have to set each channel to flat audio (I cannot confirm this at the moment) Make sure you set in accessories TX Flat to Pre limiter for best response. Good luck.

IIRC, there are a few boxes you have to correctly set the audio. I ran into the same issue first time I did an R1225. Andy (TARRA) via groups.io <tarra@...> wrote:

I didnt explain it very well. In order of appearance from the antenna: 1. 144.610 rx? ? ? ? ? ? ? ? ? ? ?c2037 2. highband vhf rx? ? ? ? ? ? c2037 3. 145.210 tx? ? ? ? ? ? ? ?

He did say "the "flat audio" check box enabled in the RSS software.". Mick - W7CAT

You have to change it in CPS. Show the screenshots from CPS, then we can help. Thanks Andy WJ9J [email protected]> wrote:

Good Day All, Just reaching out to see if anyone has had any issues with Motorola RKR1225 repeaters not producing flat audio on pin 11 of the accessory port with the "flat audio" check box enabled in

Ya I had seen that one and it was tempting, 6-7 hour drive for me. Kory Links: ------ [1] /g/repeater-builder/message/215400 [2] /mt/103940517/6175112 [3]

All, I am looking for 1-2 Micor Mobiles and/or 1-2 GE Mastr II mobiles potentioally a station if the price is right and its close etc. I am looking for 100-110w radios, on UHF 450-470mhz.? Please

If your near Kentucky, there is one listed on Fleabay.

Repeaterbuilder has the diagrams for other cables. Can't you use that schematic? or do you need the pinout of the mike connector? Joe. K1ike

That's it!! Tnx John!! Chris WB5ITT [email protected]> wrote:

Chris, I think that Rob Riggs had something here https://nbviewer.org/github/mobilinkd/KenwoodTK-x90/blob/master/Kenwood_TK-790.ipynb <setxtelecom@...> wrote:

Due to my former company keeping my Kenwood programming cables, I'm kind of stuck right now. I've got two tk790s I need to reprogram the frequencies and I know that front panel programming won't allow

It all depends on where you're shopping. I find good deals on Facebook and the internet for antennas and I bought a duplexer out of the city of Auburn California, a TX RX 2 m 6 inch cavity version for

I get a discount at Tessco, but with shipping the DB224-E was going to be $2K, tariffs hit aluminum antennas hard, duplexers jumped up too. I ended up ordering a Sinclair Aurora, that was $1500