开云体育

Good Morning Rich: I believe that the LA-1K requires a PTT, unless your FTDI interface has a relay to key the AMP it probably won't work. I have an ANAN 100D , there is a PTT port on the rear of the

Trying to get my LA-1k connected to my Flex 6600.? I have the FTDI cable and then null serial cable from there. It runs my STEPPIR controller just fine but not the amp. When I change the mode in the

Does the RCA port on the La-1k replace the Xtronics XDC-1 ? Can I plug the RCA cabled port directly to the Bypass port on the ANAN 100D. Thanks for the feed back. Mark Reinen? K1SRE, Phippsburg

Also forgot to mention I use Splashtop as a streaming server on the shack computer and as clients on my Android phone and my portable laptop to operate on the road. 73 Paul NO0T Paul Sobon 1700

The relay is a double pole so it switches both sides of the 240 at the same time. It has two connectors for the 120v and 4 connections (2 for each of the 240 lines). The coil on the relay is

My memory is tired this morning...As Paul Sobon pointed out it requires the "H" update to the amp. Neil

Let me clarify my "remote" usage and sorry if I was not clear. TRX-Manager has support for the LA-1K monitor and shows a representation of the front panel of the amp. This allows me to monitor on

I guess I should have read the description where it said 8 pin, 120v is for the coil. Thanks 73

In this case the 120 volts is the relay voltage. You could use that or something else. “double pole” I the important part. *From:* [email protected] <[email protected]> *On Behalf Of *BJN644 *Sent:*

Thanks for the reply Paul, that all makes sense except for the relay. How do you switch 240v with a 120v relay, are you just switching 1 leg of 120v ?

Not if you understand my shack set up. I use 4 monitor screens and operate facing the screens. The LA-1K is behind me. If you check out my QRZ.com page you will see the older 3 monitor set up. I have

Hi folks I don't like to leave the LA-1K running all the time so I built a remote power switch. I bought one of the gray outdoor electrical utility boxes from home depot and some power cord and 240

"?I have the amp on only when I am in the shack operating" Kind of eliminates the need for remote software doesn't it ?

That amp has a toggle switch for on/off. It is not "software" driven. I have the amp on only when I am in the shack operating. Neil

do you have a way to remotely power the amp on and off, or do you just leave it on all the time ? Doesn't look like the software has that capability. 73

By the way you will need to upgrade the LA-1K firmware to 1.03H for it to work with TRX-Manager.? Then all you need is a free RS-232 port on your computer and a straight (not null) RS-232 cable and

Hi folks - I've been running the LA-1K (love it) totally remote for few months with the help of TRX-Manager author Laurent F5DEX. Laurent worked with the Palstar folks to emulate the touch screen in

Here's the link for others that might be interested. http://www.trx-manager.com/index.html

well, I got a quick reply to my email if the software works with the LA-1K. They said "absolutely, and it works well", it's going to be released this week. They even offered to send me a test version

BJN: I admit that was one of the first things I went looking for -- to have the amp go into bypass whenever my HF-AUTO tuner was tuning. I looked at doing that using the tuner interface on my Icom