Hubert,
It might be that you need to use "Request update of sensor"
instead of "Request update of all sensors".
Daniel
LogixNG: IQ:AUTO:0004
??? ConditionalNG: IQC:AUTO:0004 ::: Startup
??????? ! A
??????????? For each value, set variable "sensor" and execute
action A. Values from Sensors
??????????????? ! A
??????????????????? Request update of sensor by local variable
"sensor"
LogixNG: IQ:AUTO:0004
??? ConditionalNG: IQC:AUTO:0004 ::: Startup
??????? ! A
??????????? If Then Else. Execute on change
??????????????? ? If
??????????????????? Sensor IS1 is Active
??????????????? ! Then
??????????????????? For each value, set variable "sensor" and
execute action A. Values from Sensors
??????????????????????? ! A
??????????????????????????? Request update of sensor by local
variable "sensor"
??????????????? ! Else
?????????????????? ?
On 2024-09-26 21:27, Hubert Holmes
wrote:
toggle quoted message
Show quoted text
Phil, sadly no joy for me on that LogixNX sensor polling
command. it appears to run at startup and even if I force
execution it, it still fails to give me block occupancy
visibility on the panel. I guess my lr101 and/or lb101s just
dont wake up from it calling for the report. I have a little BLI
track car I just plonk on a couple blocks within easy reach and
all is well, so not a huge time saver, but was bummed this
didn't work for me. I did get the route to clear the turnouts on
startup, so that was a win.
--
DiverseHobbies operates a:
10x16' HO multi track layout; Lenz LH101 throttle drives a
LZV100 for JMRI Automated Sections & All Turnouts with a
Slaved LV102? booster for the manually controller portion of the
layout Mains. JMRI is running on an HP Envy 15" touchscreen w/
AMD Ryzen 5. Lenz LI-USB interface on COM 5.
