开云体育

That is possible that no one has written a definition for that yet??

Never mind the 4 page report on registry, pointless, unless someone else wants it.? I've been thru the Win10 registry several times myself deleting anything relating to JMRI.? While it is a

I am experiencing what sounds like might be a similar phenomenon. I have a panel developed in panel editor.? The panel is quite wide. Upon initial loading the track icons on the right portion (say

If DecoderPro reported Zimo, then it read CV8.? A match to the? CV7 value? is probably the one item not found in DecoderPro. Marc

I found a vendor who has built a WiFi set of modules that can be installed in a battery powered locomotive. His software outputs to an Ethernet network router that connects wireless to his WiFi

Have not looked at cv8 or 7 yet, but latest test version of JMRI, just downloaded today Robert J. Richter 283 Elm Street North Reading, MA 01864 Sent: Sunday, December 8, 2019 8:53 PM To:

Following your link for F-Secure, I have nothing quarantined. I will start a thorough scan before I quit for tonight - just because. I have been looking at the logs & have not gotten all the way

Charlie, A lot will depend on who is the master clock. To have JMRI as the master clock and it drive both an NCE and LocoNet with that data is pretty straight forward. Having the master on one

My system is NCE Procab with a stand alone Loconet. I am using the latest test release4.17-6. I have a Logic Rail Fast clock ( Loconet ) ?hooked up to my Stand alone Loconet and it is working

Missing some details here. If your Command Station can change the address, no reason for JMRI to not do same (if going thru Command Station). But you are high jacking someone else's thread.? Please

That is simply the electrical connection type (6 pin) and not a model. Marc

So it is not a Motorola decoder after all. What? are the values returned by CV8 and CV7 ? What version JMRI ?? you should be on latest before throwing in the towel. Marc

I too have a ROCO locomotive and when programming with the decoder pro the response says it a Zimo decoder. However on trying to assign a number it does not allow any numbers. Using my Digitrax

Not so sure, it is detecting a Zimo decoder, but the numbers only go up to, I think, 649, and I have what the Roco website says is a NEM 651, so maybe I need to wait for the 651 to be programmed, now

This enhancement has been merged into 4.17.7, and will be in that release and 4.18 when it comes out.

Hello, My name is Craig and I am new to the user group. I love the JMRI program and have used it in the past at both home and a club I used to belong to. I recently moved and can't seem to get a

Hi Dave Great to hear from you again. Thanks for looking through and commenting on P2a12b. I shall put that right. Regarding Sensors, again your comment is correct. I changed strategy as can be seen

Peter, Turnout P1b has Inverted selected. I try to avoid using Inverted if at all possible. It is a potential issue I like to avoid. The P2a/P1b slip definition is messed up. The Turnout A/Turnout B

you are screwed as far as decoder pro is concerned most likely.

I take it then that this is a three rail AC locomotive with a Marklin Motorola format decoder? Sent: 08 December 2019 20:54 To: [email protected] Subject: [jmriusers] Roco locomotive / Motorola