Hi Dave
Great to hear from you again.?
Thanks for looking through and commenting on P2a12b. I shall put that right. Regarding Sensors, again your comment is correct. I changed strategy as can be seen in the North ladder turnouts, Sensors are taught to the Servo modules and I standardised on those turnouts in the North Ladder to use events 10 upwards, in pairs, for each servo to avoid any potential clash with servo and Sensor events (each module can have a maximum of 8 Servos attached). This is part update I planned to carry out when I resolved the P9/10 issue.
I also discovered that I did not have a proper handle on assigning the A and B turnouts. This I found when I built up the two slips in the North Ladder. When I first assigned them to these Slips, I took the end with the 'blue connector as being the 'A' turnout and it resulted in problems when testing. I reversed the assignment in the slip Edit Dialog and this cleared the problem. I had in mind to change P2a/1b and will also do that now.
I am looking forward to completing the layout panel and then I shall start to implement the signalling that you tutored me on.?
Perhaps Steve will help me with the North Ladder Slip.?
Best wishes
Peter
