开云体育

Ken, I found 1, 2, and 3. They were all good. Where do I find the "verbal feedback" option at? Also are you saying to remove the grain of wheat bulb? I also have gone back to 4.12 version. I have also

I have upgraded many times without problems, but my latest upgrade has failed. I am running on a Toshiba C655, Win 10, Java 8 181, with a Locobuffer USB connected to a Digitrax DCS 200. No error

Hi Try a resistor between 500 and 2k ohms for Lenz, tcs. The value of the resistor matters. The BLI decoders need the audio feed back disabled. Steve G.

I just bought 5 emd locos from broadway limited. They are the new sound decoders something3 Jmri will not identify the decoder on a random basis. Try selecting the decoder from the list and write a

I was never able to consistently read TCS, Lenz and NCE N-scale decoders with an original Zephyr, either direct from the command station, or with DecoderPro running on a Linux laptop connected with a

Cwt, First I'd suggest you stick with 4.12, there are issues in 4.10 that are likely to bite you sometime. Next, make sure you can select if you use the PowerPax and select to disconnect the grain of

I am using version 4.10 and have tried 4.12 JMRI on windows 10. I also am using a RR-CirKits LocoBuffer-USB version 3 on com port 3, a Digitrax DCS 200 and a program booster (PowerPax) to the program

Thanks Steve Yes I did that and all are well now, regards Manos SV1IW

Hi Manos You saved them: tools->file->save->save configurations only to file. Then to load: Panels->Open Panels Steve G.

Thanks again Ken, got them all sorted out, so far. If I load the tables from panel menu (had them saved with a different name) all return as expected. The reason I didn't do this before is that

John, What you are seeing is one of two things. First it could be the command station. When it does a power on to the track, it sends special commands (what you see) to ask all devices on the layout

JMRI is querying for the status of devices connecting to the LocoNet. But for some reason, perhaps because layout power is off, the command station is rejecting the requests (that’s the “Switch

If I have JMRI running on my computer and then plug it into my Digitrax command station this comes across the loconet monitor screen (just a sample of the full trace) Interrogate LocoNet

Hi Paul, ?? I mentioned in an earlier message that I hadn't been able to recover a largely working layout from a number of changes and updates etc., most of which were relatively minor, however it

I recall someplace (so usefull I know) a toggle to put a delay between throwing turnouts. It sounds like this could be enabled. [email protected]> wrote:

Assuming that the engines always run together. Set both to run headlights based on consist address. Set both to never turn reverse headlight on. If you're worrying about horns/bells, etc

Hi Dave All these items you have come up with were caused I think by me following the suggestion in the Check menu as mentioned previously. I think I will have a look through my backup files and find

Option Reset previous Aspect does not affect the result. When I switch the turnouts from the Turnout Table, there is no delays. *07:05:05.726* : [packet: 52 1A 88 C0]? Accessory Decoder Operations

Manos, Ok, here is a few quick clues. First if you do a save in the tables, it creates a file that is same as if you did Panels->Save Panel, but the tables only saves the table items. I always use

Hi Ken, I did save the parameters but could not find a way to reload from the same menu (tools->tables->turnouts). Reloading was my first thought but I guess this happens from the startup of the