开云体育

Phil Is this the build report that works, or the one that fails? Dan

Sudden memory: Go to Preferences->Defaults and check that NCE is selected for everything, rather than Internal. -- Dave in Australia

Norman, Instead of sending the file to the printer, try the "Microsoft XPS Document Writer" and send the output to me to review. You might have a printer that doesn't quite work right with JMRI. Dan

The "nce.NceConnectionStatus INFO - NCE EPROM revision = 7.3.0" in the log below indicates your drivers, jumpers, baud rate and JMRI settings are correct and that JMRI can communicate with your NCE

Geoff CMRI communication is well defined in this document: https://www.nmra.org/sites/default/files/standards/sandrp/Other_Specifications/lcs-9.10.1_cmrinet_v1.1.pdf There are four special characters

Due to a firmware problem, the NCE Power Pro is incapable of correctly programming CVs>256 in Program Track mode (a CV<256 will be reprogrammed instead of the correct one). However you can program

Update, tried WiThrottle (Android), starts loco going, but loses it, no control at all. Tim

OK thanks Paul. Throttle works, as I would expect it too. I am unable to test any programming as I don't use the Z21 for that purpose. Now onto the next but minor problem. I have done a workaround,

First apologies for my tirade about the new version. I could have been more tactful. As for 4.7.6, after about a day of testing and tries, I have given up on it, and gone back to 4.6.0, and all is

Thanks, I will see how I go. (It may prove easier for me to wait till you have moved ED to AndroidStudio.) Peter ---In jmriusers@..., <mstevetodd@...> wrote : Thanks, Peter. Those changes

Billybob, Thank you for confirming my observations. I am planning of extending hardware bits using the shift register method and I am now a bit worried that C/MRI operation of updating changes may

P.S. here is a screen shot of 4 Lights sequentially swicthed to ON [41 54 01 00 00 00 00 00] Transmit ua=0 OB=1 0 0 0 0 0 [41 54 10 03 00 00 00 00 00] Transmit ua=0 OB=10 3 0 0 0 0 0 [41 54 07 00 00

Sorry, but neither of those is right. It sounds like the LI100’s USB connection isn’t being properly being seen by your Mac. Perhaps there’s a driver that has to be loaded? Bob

I have missed something, and cannot see what. In one spur (IGA Dr 1), I have a reefer that is scheduled to be picked up (which would make room for a new car), and I have a reefer in a yard that is

Hello name?, That 303 error message, that can only be generated if the command station responds to the system with a message that says the command isn't supported. You said in your original message

Mike R,

Tim, Can you open up the preferences and then select the "Defaults" panel from the menu on the left. Make sure that everything is set to either the Z21 or Z21XPressNet connection (it shouldn't matter

Once again I tried searching for this one and failed. So please bear with me if this has been asked previously. I want to print the cars at just one location. So I go to that location, and under tools

Here's the help link to staging tracks: http://jmri.sourceforge.net/help/en/package/jmri/jmrit/operations/Operations.shtml#Staging

Geoff, Yes, that is a correct interpretation of the C/MRI protocol. The C/MRI protocol does not have any message formats which deal with only one output, or only one input. It only has formats which