开云体育

Ken; This is the closest I find "JMRI applications will not load a panel file that fails XML validation; an error will be shown that should explains the error, allowing it to be fixed using an editor.

Mike, That isn't what I was referring to. There is an option on one of the throttles ( it may be the LH90 ) for setting the stop button to send an off or an emergency stop. The manual/auto power up

Ken, Again thanks. I read all the release notes for 4.7.x and didn’t see anything regarding normalizing names that have leading space(s). Not sure if trailing spaces are included in the process.

The first thing is to ensure that you have reinstalled the SiLabs CP210x drivers from the SiLabs website: <http://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers> and

Jim: I saw you signature after I had posted. If "Breezlys" fix did not fix it, can you control the locos with a Digitrax hand held throttle? Walt

Thanks Paul. The DR5000 has Wi-fi (router) and lan built in. I have tried to use LAN, Wi-fi and also a Lenz 23151 LAN/USB with XpressNet to the DR5000 I have got a set 100 also, which I’ve tested

Jim, It sounds like your command station is in "Stop" mode. I'm not sure how to correct that using JMRI, maybe turn the power on twice (can you even do that or does JMRI toggle between off and on)?

Hi Walt. I did sign my name...it was a few spaces down on the page and I apologize. Thanks for answering me. After fiddling for several hours I have noted the following: 1. Power on/off works well and

John., Thanks for the suggestion. Yes, the appropriate cars are there on the 7 missing tracks. Norman

Dan, Thanks. I have checked them carefully, and found nothing. But I have to believe that, as you suggest, something must be set wrong in those tracks. When I get time over the next few weeks, I will

John, Yes, the appropriate cars show up on the "missing" tracks. Thanks for the suggestion. Norman

Dan, I appreciate the quick response. But you missed the point. I cannot even select any or the seven tracks in order to build a train. I can select any of the other 43. Each train is built from one

Hello everyone, I am trying to figure out signaling, I have made a simple 5 block track segment with signals protecting each block boundary, I have created blocks for each section and put in virtual

Hello all, I recently had my PC restored by a low level format and then upgraded to Windows 8 (from Vista). I downloaded the JMRI version 4.6 and started using the WiThrottle right away with no issue.

I suspect it means that you are not connected to the command station from the computer. Can you turn track power On and Off using the JMRI 'Power Control" tool? Signing you name help us talk to you.

If you can't quickly figure it out, the train's build report will state why the seven tracks were ignored. Dan

Mike, On the LH100, I believe there is a setting that sets whether the stop button sends an off or an emergency stop. ( I may have that confused with another device though, not looking at a manual and

See below: Correct. When addressing a consist, NCE command stations: - Always sends speed commands to the consist address. - Always send function commands to the lead loco alias (or rear if you select

Just out of curiosity Look at you car roster sorted by location and see if your cars show up on the"missing" tracks John Birmingham

Norman, The program will only list tracks that the train can use. Look at the 7 tracks carefully, there's something you did to tell the program that those tracks can't be used. Let us know what you