Hello everyone,
I am trying to figure out signaling, I have made a simple 5 block track segment with signals protecting each block boundary, I have created blocks for each section and put in virtual occupancy detectors. I did the discover signal logic option for each of the signals. When I set the sensor for a block to show occupied the track section turns red but the signals all remain showing the 'clear' aspect. I can change the aspects of the signals by clicking them but none of the others will change, ie I would think the signal approaching the stop aspect should show an approach aspect etc. What am I missing here? Also if it helps I am using the BNSF 1996 signal aspects with virtual signal masts at each section boundary.
I have followed the instructions of both signaling guides found on the JMRI website to no avail.
Please help,
