开云体育

Can you provide a screen shot of the window?

Correct.

Is this a DCC-EX connection issue, or is it about the steps needed to utilize the signal head once it exists in the signal heads table? Did you follow the instructions to define the logic within

I generally avoid overwriting a panel file. Yes, it is a bit more work if I'm autoloading at startup as I have to update the startup for the new name. But there are too many ways that a new store of a

Dan, I guess I was thinking that the program would just build and send the loads to the off spot until space becomes available at the final destination. BUT….I was wrong. I have made the changes you

Hello, I use JMRI 5.9.4 and a Sprog 3 v2.5 programmer. Unfortunately there have been increasing problems with Lenz, XION and also ESU decoders >= V4 recently. There is no reaction to pressing

I continue to explore JRMI and especially the signals. I try to set up a three-light signal. My environment : JRMI 5.8 on windows DCC ++ running on a arduino mega What I did : With "Configure DCC ++

John, Since you have issues with file management, I would recommend doing the stores with a new name. Dave Sand

Dave, Update... I checked for the correct address in line 1 ( <?xml version="1.0" encoding="UTF-8"?>) in a more recent panel file (Aug23-24). It had the correct line 1 so I loaded that one. I went to

Thanks for the reply, Dan.? When I bring up the first ROUTES screen, I know I have to put in a name first, then hit ADD ROUTE.? As soon as I do that, the STATUS button shows an ERROR and I can't put

Dave, The copy of the file (Aug20-2-24) in the "Load Tables and Panels" screen, does not open properly. If I am to use the copy that is in Windows File Manager (it has the <?xml version="1.0"

Brian, my first test is: Can I control that locomotive with a JMRI throttle? (Tools -> Throttles -> New Throttle in PanelPro, Actions -> Throttles -> New Throttle in DecoderPro, I believe) That will

For more info on adding a route and the locations see: ( https://www.jmri.org/help/en/package/jmri/jmrit/operations/Operations.shtml#AddRoute

I'm looking for suggestions as to how to troubleshoot a failure of a WiFi Throttle to communicate with an NCE PowerStation command station. Information behind the problem: * TCS Throttle can connect

Doug, Do you get this window after you've hit the "Add Route" button in the "Routes" window? The next step is to select the departure location for the route added, then the next location using the

I am brand new to OpsPro and have run into a snag.? I want to start very small and minimize the screw-ups if possible.? I have managed to successfully make it through SETTINGS, LOCATIONS, CARS and

Mac sequioa is 15.0.1 Jim

Where do you expect car ACFX 72089 to go?? If Dunn Papermill, the setting for inbound cars from staging is set at 100% which means that only one car (44 feet of track space) from staging is

On my panel all turnouts are within a block, not their own block. The thru and diverging tracks from the turnout become separate blocks although in some cases I have simply continued the 'mainline'

Hello again, I got one set of build fails cleared and am now onto this issue. ?I have attached a build report for your reading pleasure :) it seems that the program is not using off spots for extra