开云体育

Dave, Those directions are missing a step near the beginning. You need to delete or rename the existing home/pi/JMRI folder first. Failure to do so will eventually bite you, as old, renamed libraries

Sometimes our best thoughts occur at weird times e.g. in the shower. Recently I made some major trackwork changes. The guy who wrote my Visual Basic program for CMRI is no longer willing to make

Wow! I stand corrected. Yes, a 1K ohm resistor, or a 12v light bulb. And I apologize that since this is a JMRI forum, I must admit to not being familiar with that. Just that IMHO the only thing I do

This goes against the method I've used in the past to "update" JMRI. Steve Todd in his reply to #153540 "JMRI update on a raspberry pi". cites how I've always done it. " Regarding updating JMRI: Note

Hi Steve Thanks for telling me that it should work. I reduced my program to two lines, and it worked successfully. I have now modified my original program so it works, and am slowly putting back full

Frank, For planning purposes - the number of turnouts is not necessarily the number of columns. Often, a pair of switches for a "crossover", and the "crossover" is controlled by one "switch" lever on

FYI - Mike Burgett's CTC machine is currently 4 30" cabinets plus one 60" cabinet. That equals 90 total available "columns" for levers. The number of columns actually populated is something like 50

Wayne, At this time, just another computer, with much bigger screen definition, that's in the same home. If this gets working well, any remote would be via an external VPN channel for security. -Ken

Frank, With mainline turnouts you have two independent issues: DS control or lock. If you treat it as a locked turnout, DS has to release the lock before local crew can operate the turnout. Either of

Ken, Are you dispatching over the Internet or just “remotely” from another room on the same network? Wayne

Thank you! -- Bob Jacobsen rgj1927@...

Figured it out by reading some older messages. I added the 'Report' to 'toReportString()'? and removed the 'toString()' later in the script. Probably obvious to you code gurus but took me a bit to

Paul, I did some experimentation and believe I have found a solution, or at least what I want to happen is now happening ;-). I was running a script with an error in it at startup (topic 167239). When

Thank you for the info Inobu.? The dispatcher will have control over the whole railroad mainline. Thank you, Frank

Thank you Ken.? I'll have to process this for a bit to see how I am going to do this.? I loosely laid it out on a piece of paper to see what I was dealing with.? Yes, about 8-10 are crossovers and

Frank, The panel I mentioned was 50 some odd switched. Trying to get them on one panel wasn't hard. The issue was managing the panels operation.? It is easier to pull up say.... a Fresno and

Frank, What I've done is created thinner versions of the normal screen parts, but many times I've used thin fillers between the normal parts to give a little space for fingers and the diagram above

*From Tony's Train exchange Special Application Notes* For BLI Switchers and Proto GP9: We found that sometimes a 12 Ohm 1 Watt resistor (Digikey P12W-1BK-ND or equivalent) placed *between the

Hi Guys, What is the best way to PLAN the CTC panel?? Meaning, how much space to allow for the turnout/signal icons on the panel?? I'm using two 22" monitors and want to make sure to have enough

Hi Bill It should just work. Is this a point to point or around and around? If it continious make sure theres a delay, I do know that can be an issue. If you make the file load on startup does it work