开云体育

Hi Ken, Thats make a lot of sense to me thanks for the explantation. ?It fits with what I am seeing so I have decided to remove the signals from routes and go to a manual signalling system by

Pull Request (PR) 6224 has a change to display slots that are not in FREE state. ?It should be in development builds shortly, and then the next test release around December 4th. ? The discussion

Thanks Dave, that was the problem Subject to fat thumbs and strange spell check changes. _Ernie

Another option could be to set up a 'route'. ?The route would set all the relevant direction sensors that are referenced by SML to INACTIVE, ie. simulating the protected segment being allocated. ?

Don, Based on my understanding of the situation, here is what I would do. I would create an “OR” Logix that takes the 24 optical detectors to set an internal sensor that is assigned to the block

Ken, Sorry, I was wrong. Only the circle size is used. Dave Sand

My hidden staging tracks are arranged as a double track reverse loop. It was originally wired for DC, but now has DCC. Initially, each of the two tracks was divided into three blocks, with eight

My normal layout runs with NCE and that is fine it acts as you described? I have built a DCC++ with a rasberry and playing with it on a test track

DCC++

Which dcc command station have you connected your Pi to

Dave, Yes, I'm using LE and I've set the turnout circle color to yellow and the track circle remains black. Ken

Thanks Peter, that's the rub, it doesn't change when I click on it ? Regards Stewart -----original message----- Sent: 30 November 2018 15:00 To: [email protected] Subject: Re: [jmriusers] power

The unknown button will be amber. Click on it and it will change to red for off and green for on and it is the status of the power to the track. It is unknown at 1st as no status has yet been set

Good day guys I am trying to set up jmri on a rasberry Pi and when I open a throttle panel it shows status unknown What am I doing wrong please?

Doug, Here is an important point to keep in mind. The changes flow downhill so to speak. If you have a mast that is built from heads that is driven by turnouts, there is an order to how they work. If

Thank you to both of you.? I have tried to look at your suggestions but it either does not work as you suggest or I cannot find the relevant options. All I want is a very basic control system where

Thank you Thomas! this adds some elements to our test setup. Thank you so much. Christophe

Thank you Michael for your answer and your information. We will test all this at our next meeting at our club. thank you so much. Christophe

See below: This doesn't matter one little bit as the Portable Format accounts for this. <http://jmri.org/help/en/html/doc/Technical/FileNames.shtml>

Your layout files (and any associated files) should always be stored in the User Files Location (Help->Locations->User Files Location) of each computer. If you do that, JMRI will make sure all file