开云体育

Martin, Where does Digitrax say this? Dick :)

The Acerpc is 75'+ away from where the Layout computer, CS and LNRP's are. (You? have been to the layout and these units are in the opposite corners ;>)? I can run another dedicated Loconet cable to

The Acerpc is using the Loconet over TCP per the instructions for a client on the JMRI Web site.? The physical connection is WiFi.? Both systems can ping each other via IP address.? The NUC is

Dave, As Dick has said, a bad idea. The ground wire needs to be parallel to the signal wires and go directly to the AIU ground. To do otherwise invites trouble, ranging from false triggering to

Ken, Take a look in the Help->System Console, it may give us other clues of what happens when you try programming. I'd also say try something like the 'Single CV Programmer' but only if you have a

Marc, I do not get the option to set to page mode, only automatic. Your talking about the "programming mode" option drop down menu. Thanks, Ken

Ken, I no longer get the error message at the start of decoder pro. connects no problem I got the adapter to see the MRC system, as cab 2. My issues is now it will not read any decoders. I press the

Dave, It would be best if your Tortoise pin 5 'GND' connection ONLY connects to one of the two 'GND' terminals on the same AIU that is reading the data. That would put it closely parallel with your

Thanks Ken Yes I was thinking the AIU being used as Sensor in the Sensor section of JRMI. Thank for confirming that Dave In PA Sent from iPhone Xs Max

Thanks Dave for chiming in. The AIU board Gnd is connected to the Separate Accy Power Bus, on the “-“ side of the power supply. So am attaching Pin 5 also to the same Gnd on the Accy Power Bus,

Dave, Your example of using two pins from the Tortoise is call 'Two Sensor' feedback. Since there is a dead band in the contacts on the motor, you will get a period of 'out of correspondence' where

Martin, Why will a LocoBuffer-USB not work on a 'protected' section of the LocoNet if that is closer to your panel computer? I thought that 'protected' and 'unprotected' just has to do with Railsync

I've never heard of reflashing Digitrax decoders so would have to say no. Most issues if you haven't fried the decoder can be fixed by doing a factory reset of the decoder. With your roster entry

Dave JMRI (PanelPro) certainty supports the NCE AIU board, which connects to the Cab Bus (not the DCC Accessory Bus). The Switch-8 connects to the DCC Accessory Bus. There is one error in your

Hi all, Is it possible to add a digitrax decoder firmware reflash option to a future JMRI update? I have a few now that a uhlenbrock intellibox seem to have corrupted the firmware in. Cheers Stu

Paul, I am looking forward to hear about your findings. The script I was testing it with only changed - or tried to change - the CAN Detector Messages flag, leaving all the LocoNet flags set as the

I would like to know, in the scenario shown in the link below, would detection of the switch alignment, show in Panel Pro, using the tortoise’s internal switches, connected to NCE accessories as

I will look into that.

I don’t know if this will help, but a local N scaler purchased one of BLI’s Mikes recently and was unable to get it programmed. I found a brief mention on another forum to try the following: “

Tim, The earlier BLI locos used QSI decoders and it was essential to turn off Verbal Acknowledgement of CV writes (set CV62 to 0)or it would mess up CV read/write operations with JMRI. It affects