开云体育

Doc, There has been a lot of changes over those years. And a lot has been done in the last few months with the phone throttle part. I'd suggest going with 4.14 as the right choice. -Ken Cameron,

Dave, Sounds about right. I've got one other system that seems to show two 'All Users' in the roster group list. Not seeming to impact anything, but not sure what's causing it. -Ken Cameron, Member

Andy, It may be related to the panels you are trying to click. In my opinion, a panel that works well with a mouse on a large screen is likely to be a real pain on a tablet. I would recommend

Make sure that 1) Preferences->Defaults has nothing set to Infernal. 2) Preferences->Connections does not have System Connection set to Simulator. Possibility (1) is the most likely. It would most

I seem to be having the opposite UI benefit of many of the posters here. My personal experience of small touch screens is of having a consistent around 80% input error rate for keying. And any sort of

My train club is using Window 10, Nce with a Sb5. For the last two years we have used JMRI version 3.1 with no problems but now When using WiThrottle the cell phone shows as being connected as is the

Charles, Our club layout has thirteen Android tablets that originally augmented and now have partially replaced hardware control panels. Many of the tablets were donated by members as they bought

Or: *) Start DecoderPro. *) Select the "Open PanelPro Window" from the "File" menu. The advantage of Bob's solution is that the process can be automated by adding "Open Roster" as a Startup Action to

Ken, My memory of a previous issue like this is that may be a combination of two circumstances: 1) You have created a new group but not yet added any roster entries to it. (The act of creating it

What kind of switch machine is he driving with this? Twin coil, tortius, reversing stall motor, Jim

Charles, I use the JMRI web server to wireless communicate with a iPad that I use as a walk around control panel. Check out the web server guidance in JMRI documentation. JMRI will create a web server

Greetings and Happy Holidays to all! I want to control the turnouts/ routes in various yards on the layout with touch screen monitors. So far I have set up several panels in layout editor and have

Go to Google Search, type in "JMRI donations", will take you right to the page. John

Seasons greetings to all Where's the collection plate located? John Stewart Birmingham

HP, crew: If HP is seeing a nominal 5V on the output pins no matter what has been sent to it it's not seeing commands to turn on the output ie pull to ground. But wait... a couple more basic questions

Since *) Polling works *) Sensors work *) The SM2 works *) You say the ground are good *) You’ve checked the output voltage *) And the init message was "Init ua=0 type=X DL=0 NS=1 CT: 16”, which

I need a diagram of that board. If you have one then e mail it to me jlefevre1@...

Tim, One more point. Engine sounds (start-sound, shutdown-sound and notch-sounds) _must_ have the same audio format. The format should be either 8-bit-mono or 16-bit-mono, but not a mixture. Klaus

one input wire ... turnouts operate from sm2's if you force voltage change from 5 volt to 0 volt ... and vice versa ... but output board voltage is 4.98 volts at connected bits and doesn't change ...I

I have misplaced my SM2 board diagrams. How many input wires to the board does the SM2 require. One for coil A output and one for coil B output or just one wire that when on throws to coil A and when