开云体育

Hi Peter, Thanks for the reply. I thought I had done something wrong when I couldn't find my attachment on line. I have done a cut and paste as follows: CommandLine: LaunchJMRI? /debug /noisy

[... ben jij Nederlander?... ] Yes, I'm Dutch - but have lived in Scotland for the past nearly ten years now! Wouter wrote:

It can be done. See: <http://jmri.org/install/WindowsNew.shtml#sysreq> -- Dave in Australia The New England Convention 2018 http://www.newenglandmodelrailwayclub.com/content/convention.shtml

It sounds like you may have a non-zero value in CV19 (the consist address). -- Dave in Australia The New England Convention 2018 http://www.newenglandmodelrailwayclub.com/content/convention.shtml

We need to take this from the top again: - Download and install V4.12 - Check Preferences->Defaults and make sure everything is set to NCE and nothing to Internal. - Check

It seems the locomotive only uses short addresses so it is now 37 and either gas turbine or dual 645 (all I have tried) do about the same - lights turn on and off and the locomotive moves. bell rings

Thank you all for helping out, Ken, Bob, and Wouter (ben jij Nederlander?), I'm running Java 1.6 and a corresponding earlier version of JMRI because with my OS I have not been successful installing a

Rummy, Thanks for the panel and a subtle clue in your description. Instead of defining the sensor names in the sensor table and then adding the sensors to the panel, you are dynamically creating the

Steve, ? ? ?I've had control of a loco with my DT402 throttle and then ran the loco via Dispatcher without dispatching it.? I think that Dispatcher takes over the loco totally and you have to

I only input system names for the sensors at the point of placing the sensors on the panel. ?Those were the names that sometimes had the "IS" prefix added in the configuration file. If I understand

Tony Correct, you should release the loco from any other throttle. I think but not sure, that unplugging a dt4xx dt5xxx or utx will stop the throttle trying to reassert control but a dcs5x cs throttle

I tried using Tsunami gas turbine and it seems to change things, however on a run track the locomotive just makes an engine noise and does not respond to throttle nor F0 to turn on the lights. Thanks

Rummy, Table items such as turnouts, sensors, routes, logic, etc. have a system name and a user name. When you create a new object, such as an internal sensor, a prefix is added if necessary, such as

You aren't doing it properly. You need to set F2 to Locked in the Roster Entry for your Minitrix locos and select that roster entry (in the main roster entry) then press the Throttle button. -- Dave

See below: Good so far. JMRI has contacted the NCE USB and it

additional note: when I launch JMRI again, the JMRI device does not show up in the Finder Devices list. Nor does the 20GB Firewire device, now, either. I am not sure if this is a clue or not....

Thanks Dave, I’ll try again tomorrow.

Apparently there are 2 tabs, the one i was looking at was dor defining functions for the decoder pro throttle. ?I don’t see the check box tab where you can assign functions to cab numbers. I also

Finally found the problem, and with it, the solution. ?And, although I do not know what caused it in the first place, I have come up with a way to avoid it. First, the problem and solution. ?As I

If you read the "Readme" pane in the roster entry, you will get more information. There are many, many, many hundreds of LokSound Select and V4 projects and the Function names, Sound Slot names and