开云体育

Hi Steve By change of state I mean it operates the turntable either by the relevant turnout being thrown (from closed position) or closed (from thrown position). I would imagine that the same code is

Ken B, If you have a profile setup as a simulated system connection, then you can make entries in the tables and save them just fine with just the computer. I don't recall which command station your

Ken I assume you mean to define turnouts in which case the answer is that you can do either. I find it easier to do it with everything connected up and then you can test each turnout (or group of

Hi John K, Do I need to be connected to the layout and command station, or can I do it stand alone on my laptop ? Ken B Sent: 01 August 2018 09:10 To: [email protected] Subject: Re: [jmriusers]

i had an excel file with 62 engines. ?I am following the website instructions i eliminate all columns except the 4 requested i save it as a cvs file and place it in the file area of the profile i

Apologies for the world's scruffiest post! It should say Hi Ken Define the turnouts in the Turnout table of JMRI Use names that mean something rather than numbers; is my personal advice John K

Hi Jen Define the turnouts in the Turnout table of JMRI Use names that beam something rather than numbers is my personal advice John K

This one appears to be the single motor version. Darn sound decoders cost more than I spent on the loco. -- Rick Jones ...And god said, "Microsoft Windows!" and the whole world crashed.

Rick, Forgot to mention that one motor of the two motor version runs in reverse depending on the direction. So when you wire the decoder make sure the motor leads are connected properly. Al Babinsky

Rick, The Spectrum 44 ton dual motor do not run well and have not much pulling power. The single motor Bachmann 44 ton is much better and comes decoder equipped. I have installed a ESU sound decoder

The link below has all the details and information, including registration form, partner's program, venue, clinics and presentations etc. But of course the website can't convey the full sense of New

Rick, It is no problem to add sound. A lok sound micro or other brand of small decoder with the motors wired in series and a keep alive the loco will run great and sound great. With out a keep alive

I popped the shell and it is a Digitrax DZ123. I'll probably want to replace it with a sound decoder. Space appears to be at a premium for putting a speaker in there. I suppose it's off topic to ask

Have you tried USBDeview? free from Nirsoft? | | | | View any installed/connected USB device on your system USBDeview is a software that lists all USB devices that connected to your computer, and

Daniel, If you always have the PR3 plugged into the SAME physical USB port on your computer, without changing ANY of the USB "hub" devices you may be using, then the operating system will likely keep

Two suggestions: First, make sure you've plugged the PR3 into the same USB port that it was plugged into when it worked; Second if the above doesn't help (assuming you're using Windows), reinstall the

Paxton, (By the way, the UR92 is not a throttle. It is a "Duplex radio transceiver" which is intended for use primarily with "Duplex radio throttles" and "Infrared throttles".) The short (but

Dan, ? ? Possible update on your computer.? May have lost the settings.? Have you tried a different com port? Roger

Hello can somebody help me with my pr3 please. Jmri tells me I have no connection. My pr3 has a usb light on, (green)but status light is off. Which means no data . Tried spare cable no luck. I

Thanks James. I would love to visit NMRA. Unfortunately Kansas is several thousands of miles away from me here in the UK, and unlike Dorothy,? I don't have a pair of sparkly red? shoes to click