开云体育

'FT817@...' wrote: ==== - - To unsubscribe from this group, send an email to: - FT817-unsubscribe@eg ...'

'FT817@...' wrote: ==== - - To unsubscribe from this group, send an email to: - FT817-unsubscribe@eg ...'

chain also?? > That is correct Gary. Its flat response makes it also nice for PSK31 operation. 72 de Barry - W4WB

Hi You would be better off using a 12v 7 or 8 Ah gel cell battery I use one with my FT817 and get about 4 days with 5 watts before the battery voltage drops to 11 Volts. 73 Lionel

Hi! Do not worry Johan, I think the european model will cover the air band without any mods. At least the one I got few weeks ago covers it. 73 Reino, oh3ih on Xmas eve... answer was and nil at

I assume that with the opt SSB filter that it is used in the TX chain also??

Chris; I built a simpler cable/converter that works well. Go to http://www.jps.net/k6xx/ft817/817bbox.pdf and look at the bottom of the schematic on page 2. I just built the serial interface

switching power have Hi Tony, This PS was perhaps the first one identified for use with the 817 back last year. The problem found with it was lack of quality control. Some seem to work well while

The trick is try to it with a front panel HF whip on 20 in the SSB or CW mode. That tells ALL. Its like a woman with out her make-up! Bill W9WCR

worth anything. Maybe all of us ASSUMED since the specs were so close that the reality would be ho-hum )...do you think it would be possible to cram 2 in and somehow switch them? Well, one will

first from OK Don, I will try to put something together soon and post it. 72 de Barry - W4WB

Short of removing the filter physically from the radio, you are correct.

Sorry that my post was misleading. I understand that the NAR switch does NOT perform any function when it comes to using the SSB filter. However, the prior post was a little confusing in that area.

I am very interested in any data you have about the SSB filter. At first "blush" the SSB filter is a waste of money. However, I have heard from others that it is a good "refinement" for the

Found lots of tech info here. Best battery info I have run across http://www.ussc.com/~turner/ft817pg.shtml Frank W9LVC

Blech? It's the same interface all the time, you just have to (I know it's tough) set the interfaces the same on each end. Or maybe we should require the manufacturers to support USB, Firewire,

WinCE box (Linuxized?) Computing MIPS-based You know, the agenda palmtop 1) runs linux 2) has fairly respectable processor specs and 3) has an audio in/out port. Can you say Pedestrian Mobile

*No* noise problems here with the RS switching PS...been using it for about six months. Even with it alongside my FT-817 with Rubber duck antenna I have *no* noise whatsoever - even on 440! On the

I think you're speaking from a very PC-centric view. Many of us don't wanna use a PC - even a laptop - that drains more power heating the CPU than which is radiated by the antenna - just something

Geoff Wicks wrote: Hi Geoff, I used PCRPilot on my Icom PCR1000 until I sold the radio. I really enjoyed using the Palm to change frequencies on the receiver. I also have a Palm program to