开云体育

[like] David Luckensmeyer reacted to your message: ________________________________ Sent: Sunday, October 6, 2024 12:13:25 AM To: [email protected] <[email protected]> Subject: Re:

Sorry David L. Hit the next key by accident. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Couple of examples. These are not related to the air leak, just examples of plastic parts breaking. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Nilfisk would be high on my list to evaluate. David Best - via mobile phone

David K may well have the same opinion but David L is experiencing the brittle plastic. ?? Warm regards, Lucky Dr David Luckensmeyer Designer & Maker @luckensmeyer M: 0413 013 115

I second David K. experience with brittle plastic with age of Festool Vac. I sometimes grab the vac to get it over something from the top section. I have broken small protrusions around the caddy on

PK, I have no experience with the product, but Mirka could be one of the brands you may want to look into as well. Regards, J.

I also like my CT36 a lot and? probably would recommend it as well. It truly sucks...

PK, Not sure what is wrong with the CT33, but from the spec they should be really close to the CT Midi in respect to performance. CT midi - 130 cfm at 96” static water lift CT33 - 134 cfm at 90”

PK: Have you examined the used CT33 for cracks on the external housing? I have 4 x Festool vacs, 26, 33, 33, and 48, and my oldest is approaching 15 years. One of my CT33s has cracked all the way

PK I use my CT36 all the time for this and l love it! Thx, Wade

I have two small Festool dust extractors and they work well.? With the new shop, after some use and tripping over cords and hoses, I need to make a sanding station that is portable and keeps the

Tom, thanks for the tip on ordering the T130 w/mm scale. I'll be ordering one with the side-mounted tenoning carriage at the end of the year and my quote specifies North American scales. I'm glad I

To follow up, no movement on the infeed table martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

The story is told by putting Dial indicator on the outfit table on the right and the left side and as you tighten down your kip lever, you should see no Mac,, martin/campshure/co/llc mac campshure

Good point if you have a cover that needs to come off in a darn good flashlight, and I prefer couple thou brass shim so I can tug on it little bit. martin/campshure/co/llc mac campshure 7412 elmwood

One of the guides to aligning the jointer talks about closing a piece of tissue paper between the temple bolt to assure that they all are in proper tension. You might check that out.

Good afternoon all, I have just finished the process of cahnging the inserts for the first time, i.e location 2 on the intserts in line with the instructions of the Usage and Mainrance Manual and also

my 2 cents?temple bolt heights are probably not in same plane and your clamping tension is different when u clamp so changes the height of the table,they should fit perfectly flat on both heads or

Hi Jakob, Do you have a sense of what is going out of alignment? In-feed table or out-feed table? If you don't already know, you may benefit from recording some data when you do get it dialed in (for