开云体育

I did what Brian suggested and have been satisfied. Jarrett

Only few hrs left and it is 3 phase. Doubt it will remain at $500 but you never know. https://dickensheet.bidwrangler.com/ui/auctions/82816/8570096 Imran

I am looking to purchase a single phase shaper, perhaps an F3. ?Thanks.

If your exhausting out side you don’t need any filter! Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

If your Exhausting martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

I use 3M N95 paper masks. They have are comfortable, and from what I read about industrial hygiene when I began woodworking they are adequate even in very dusty conditions. Once I starts sawing or

I use the Trend Air Stealth. Very comfortable. The Miller LPR-100 is also a nice comfortable compact mask. I have both but prefer the Trend Air Stealth. John Adank

Hello Philip - I am also a DIY'er hobbyist in a home garage shop.? Depending upon the task, I use: - DemeTech N95 mask if I'm not doing a dust-intensive operation.? I would recommend the true N95

Hi All I am a home hobbyist and was wondering what people were using for personal dust masks. Have been looking at various options and don't want anything too cumbersome but of course want to

I have used a single VFD on two machines, where one was used often and the other occassionally.? ?VFD to twist lock plug,? unplug one and plug in the other.? ?The usual caveat about NEVER

In 2009 I upgraded the electronics in my 2000 CF731p single phase combo machine. Mark at Felder sent a kit to upgrade the circuit board based electronics to modular electronics. He walked me

Bob, I am curious about the electrical design of your machine. From your description it seems that a motherboard is used and Felder is not able to troubleshoot, thus a full replacement is

A selector switch between the motors could be done, but it definitely complicates things. If you have to pay an electrician to do it, and if you can find one competent, it’s likely going to cost

I am curious what your final solution will be.? I have a 2003 CF731 combo with 3 motors.? I dread the day that I burn up an obsolete control component. Instead of 2 separate VFD's, a single unit

Hi Wade, You may want to check on lemon law for recourse which in my state (Ohio) applies to retail goods not just cars. The manufacturer would be responsible for 300% of the purchase price plus

Hi Wade, That sounds very frustrating. I can tell you that I just received some parts to upgrade my KF700SP to DRO rip fence configuration, among the parts are the revised support/guide wheel (it

Yes, that may be exactly what is needed... Ed Cohen E. Cohen Designs Easthampton, MA 01027 [email protected]> wrote:

Indeed. Details here: https://flic.kr/s/aHsmwj742W David Best

Again, thanks for the great input. I feel kind of foolish not knowing this stuff, but better late than never. I just wish I was informed earlier from the sales department. Ed Cohen E. Cohen

Since the X-roll came out any attachment to the slider has to have the P-channel configuration. The backside of the cast iron table still has the F-channel configuration and as such, F-channel