开云体育

Sorry to be late with the response I did this a couple of years ago on a vr6. Get an inner tie rod remover. Remove the inner tie rod from the new rack Mark carefully how the rack attaches to the

I am running 42 psi on all 4 wheels with even wear all around on 16" Nokian Entyre 102H tires. Jim Loomis2002 EVC

Hello all! I'm trying to decipher the information on the door jamb for "Cold Tire Inflation Pressure". Not sure what all the diagrams and info means. Can anyone please help me? ?Just installed a set

In my experience, what you’re describing is what happens just before the ignition switch fails. Swap it out sooner than later. Kris S. Seago 1997 EVC “Maytag” 245K miles on original engine and

Maybe check the voltage signal strength at the interuputer. Might have enough voltage to keep the gas safety valve open but not enough to trigger the relighter board/led? The service manual

sometimes the igniter button gets stuck in the on and won't depress??? [email protected]> wrote:

I've refurbed two Norcold fridges and literally replaced everything in them with success.? a fridge I did on my 97 camper 2 years ago, complete with brand new relighter board and interupter switch

I don’t remember how I figured the engine code out. I think there is a label under the hood or maybe in the driver’s door jamb that says what it is. Regards, Mike Clough

So should I not be connecting to the 7 pin that plugs into the tail light at all? Ian

The 7 pin has the aux power. https://hopkinstowingsolutions.com/doc/trailer-wiring-codes.pdf -- David 1705.net 95 EVG(lamper) Seattle, WA

There will not be 12 volts at the 4 pin connector. See attachment for what is available at the 4 pin connector. -- David 1705.net 95 EVG(lamper) Seattle, WA

I had a similar issue back when I owned a 1985 Vanagon Westy. It was just weird. I finally ripped everything apart and discovered no less than 3 (three!) different trailer wire attachments had been

Any way - I have connected to the 5-pin for the left side but I am still getting nothing when connected to the trailer. Ian

Boy, after reading this post after all these years, I sure could have done a better job explaining just what I did. Sorry about that. The wiring notes I have on that post refer to what circuits are

Seems timely subject for me the “how to hot wire the ignition switch” My question is “does one need to be pressing the key hard while rotating to the start positon”. Seems mine is getting

David, Thanks - I actually found this post and printed your file (trailer wiring) - I followed it pretty much exactly - did have one question though. You say about the 7 pin connector that you

Janet - not sure you would see my post with measurements, because I added "measurements" to the title. So just letting you know. -- George Y 95 EVC Winnabago - Ottawa ON area

Thanks - positive it is! -- George Y 95 EVC Winnabago - Ottawa ON area

I would put the disconnect on the positive side.?That way there is no positive voltage in any of your house wiring. You may find my post helpful about installing a disconnect:

I don't have an answer for you, but the wiring breakout I have on my post might be helpful in your troubleshooting: https://1705.net/trailer-wiring/ -- David 1705.net 95 EVG(lamper) Seattle, WA