开云体育

1.) Make him help with the next installation 2.) Unbudgeted labor comes out of his commission

I am to the point where I do not believe that any money is saved by the cost savings of there boxes due to the amount of time lost in firmware updating, programming, and debugging. I have lost quite a

I don't think so... they will always be a pain to work with until they eliminate the uber-module and let us have direct hardware access like we do in a DM-MDXxX. I'v been pretty annoyed by the

Long compile times, firmware update failures, hardware failures, long boot times, long initialize times, inaccurate feedback, new device databases that make your older programs stop

So I'm having this ongoing problem controlling a Mirage Media Server. I'm using their newest module (3.1) and a Pro2. After a week-10 days of uptime, the following error pops up and the Pro2 stops

Guys Help !!! i really need help with this i have a big project that i am working with and i need the RS232 commands for this DVR or if someone had developed this module that would be great. Medo

Missed the D3 in the topic. To answer Heath's question, yes you can modify the schedule file without rebuilding and reloading the program. You would grab the schedule file off the processor using File

Tony is right. It also resets based on the processor time so if your time is not set right in the processor it could reset earlier or later.

Thanks but I just ended up running it through a variable

Yes, just run the output of the event from the event scheduler into an AND and use the button feedback to enable the other input of the AND, then run the AND into a OS or WPULSE. Mark

Is it possible to Set up a scheduler event and only have it run based on a button's feedback in d3?

Bump, still looking for any success stories. Thanks.

Guys greeting on this Holidays! I have to program some 25 Shutters via Maestro Shield, As far as I been browsing in their web site, this is what i came with: Configuration Commands UX (U1-U15) Latches

LOL!! Oops. Just a little typo. The bad part is I had not even had any Christmas spirits at that point. :)

FYI, the latest TPMC-3X firmware Release Notes states the panel will perform a "maintenance mode" (i.e., reboot) at 2 AM every day, if it's not in use at the time. Although it's not mentioned in the

I don't like that the poe switch interfaces are only correct in IE, but I just use chrome or firefox anyway and deal with the mis-alignment. The interfaces may be a little slow, but I don't find them

Should be fine as long as you don't plan to add a lot of Crestron gear to the system. I had a good bit of stuff controlled by my PMC3. I had an Xbox 360, a HTPC, Sony Blu-Ray changer, TV, Home Theater

The Prodigy stuff is on hand, and I really only need it to do some small stuff. As far as the EIC, it's just control a BDP-7000ES, a Roku, and serial switcher. Granted, I have to wait until next demo

i have an older CP2 it is in use but I will be replacing as soon as I finish new one

I am not new to Crestron but ?I am new to doing myself? Have been paying others to do this for 10 years? My turn now? Any way I bought prodigy PMC3 (hope that was not a mistake) intent is: