开云体育

We have a huge DMX system with a module for the ETC Mosaic controller including feedback. But it was a custom module written by Michael Block from Block-o-Matic that frequents this group. Try emailing

Does anyone have a module or any experience with the paradigm protocol for ETC lighting? Thanks in advance. J.

I am having the same problem with a DM 16x16 right now. I switched from a 15' USB cable to a 1' AB cable and a 15' USB amplified extender cable and it connected immediately. Doug Guth CTS, DMC-E, BSBE

NM....I found it....error in the S# must have been terminating the s+ thread

Hi there, new to the group and here to learn. I am also new to Crestron programming and have the following hardware: CP2 Processor TPS-6X Touchscreen All relevant software Does anybody have any tips

Running into a weird issue with my serial receive data routine. Device is chatty and I sometimes get two complete response messages in a single logic wave. When this occurs, the second message is not

I did find Answer ID 5060 on their site, but none of those things has helped. It looks like that AID is from 2010 so is rather old, and may not be the same problem as the DMPS3's were not out back

Well, at least I'm not alone, and I guess it's good that I carry around 2 laptops with me, so I can still into the suckers. I just hope my 2nd laptop doesn't start having the issue, or I won't be able

Hi folks, We're trying to directly control a Stingray2 from a CP3, using the CP3 IR out to the Stingray2's 3.5mm IR jack. We spoke to Jack Welsh over at Haivision, who confirmed that it is an IR

I've had the same problem for at least 6 months. Only with DMPS3. I've spoken to Crestron tech support numerous times and they haven't come up with a fix.

I have not. Would definitely like to get it worked out, as I will be on the particular job on Thursday.

Has anyone seen issues connecting to processors with USB before. I get a "USB Device Not Recognized" error from windows when I plug in the cable. Device manager shows an "Unknown Device". I've tried

Were you ever able to find somebody to correct the checksum issue that Sony told you about? Trying to control a 1060 and having issues. Was wondering if you found the solution if you could send me the

The last one released for Denon Electronics AVR-3313CI is what I used for RS232, tried for TCP/IP as explained. I have never tried the Crestron AVR Connected integration due to what I have read here

Thanks Jeremy weatherford actually i am new in Crestron programming, i just finished my basic P101 training, so i don't konw how to create a moudule. if someone already created a module please upload

Anyone can help with speed problems in code published before, Camera HE-60?

Dig into the manual. You're fortunate that Extron products are highly controllable with decent protocols, so that's a good place to start. If you have a specific question, feel free to ask it here.

Sorry missed that part, are you using version 1.1 of the module? The TX should always work, the response is what I read you didn't have Trey Sent from my iPhone 6s+, please excuse typos.

Trey I apologize but I don't see a X series module. Would you be willing to specify which one you used? Thank you,

Thank you for your reply Trey, I will try another it100 on my next visit. But I am still very curious as to why i cannot get any output on the TX signal of the power series module. Even with the